Published:2012/11/26 0:51:00 Author:muriel | Keyword: Variable Voltage , Regulator
View full Circuit Diagram | Comments | Reading(0)
Published:2012/11/26 0:50:00 Author:muriel | Keyword: Universal , DC-DC Convertor
This circuit will generate a smaller DC output voltage from a larger DC input voltage.It is quick and simple to make and by changing the value of the zener diode, the circuit can be universally adapted to provide other output voltages.The circuit and all diagrams represent a DC convertor with 12V battery input and 9Volt DC output. (View)
View full Circuit Diagram | Comments | Reading(714)
Published:2012/11/26 0:49:00 Author:muriel | Keyword: Transformerless , Power Supply
View full Circuit Diagram | Comments | Reading(0)
Published:2012/11/26 0:49:00 Author:muriel | Keyword: Variable PSU
A variable power supply with adjustable voltage and current outputs made with the L200 regulator. (View)
View full Circuit Diagram | Comments | Reading(1343)
Published:2012/11/26 0:48:00 Author:muriel | Keyword: Nicad Battery , Charger
A basic nicad battery charger using a single medium power transistor. (View)
View full Circuit Diagram | Comments | Reading(0)
Published:2012/11/26 0:48:00 Author:muriel | Keyword: Logic PSU , Overvoltage Protection
A simple 5 Volt regulated PSU featuring overvoltage protection. (View)
View full Circuit Diagram | Comments | Reading(776)
Published:2012/11/26 0:47:00 Author:muriel | Keyword: Increasing Regulator Current
An outboard pass transistor used to increase the current output of a voltage regulator IC. (View)
View full Circuit Diagram | Comments | Reading(709)
Published:2012/11/23 2:35:00 Author:Ecco | Keyword: Typical application , low-power , programmable , sensor, signal processor
The system uses 3V lithium battery (e), C1 and C2 are power supply decoupling capacitors. Crystal oscillator's frequency selects 32. 768kHz. External memory uses two 512-byte-24C04 E2PROMs. Silicon pressure sensor is shown in the dashed box. It can use temperature compensation software to get measurement accuracy and 12-bit ADC pressure value. Analog lines in the figure is connected to USDD-end, the sensor can only get power supply in a/d conversion, and it can save electricity consumption of the entire system.
(View)
View full Circuit Diagram | Comments | Reading(893)
Published:2012/11/23 1:11:00 Author:Ecco | Keyword: Isolated , data acquisition system , 5 channel, low power, programmable sensor, signal processor , microprocessor
AD7714 is suitable for low-power, narrow bandwidth, high resolution data acquisition system. 3-wire serial interface allows the data acquisition system to use 3 light couplers for isolation. If AD7714 analog input input signal is positive, the entire system can use +3V or +5V single-supply.
(View)
View full Circuit Diagram | Comments | Reading(631)
Published:2012/11/23 1:05:00 Author:Ecco | Keyword: Automatic opening , closing , curtain controller
The controller can automatically identify the brightness of the room to make the curtains opening and closing with the best natural light. In Figure 1, photosensitive resistor RD and time base circuit 5G1555 form the brightness recognition part. when the it is black to a certain extent, photosensitive resistor RD's resistance increases, 5G1555 ② foot potential is less than 1/3Vcc ≈ 2.1V, ③ foot outputs a high potential, BG2 and BG3 are cut off, J2 releases. At the same time, D1, BG1 get conduction, J1 pulls in.
(View)
View full Circuit Diagram | Comments | Reading(1381)
Published:2012/11/23 1:06:00 Author:muriel | Keyword: Dual , Regulated PSU
View full Circuit Diagram | Comments | Reading(573)
Published:2012/11/23 1:05:00 Author:muriel | Keyword: Unregulated PSU
A basic full wave rectified power supply is shown below. The transformer is chosen according to the desired load. For example, if the load requires 12V at 1amp current, then a 12V, 1 amp rated transformer would do. However, when designing power supplies or most electronic circuits, you should always plan for a worst case scenario. With this in mind, for a load current of 1 amp a wise choice would be a transformer with a secondary current rating of 1.5 amp or even 2 amps. Allowing for a load of 50% higher than the needed value is a good rule of thumb. The primary winding is always matched to the value of the local electricity supply. (View)
View full Circuit Diagram | Comments | Reading(694)
Published:2012/11/23 1:05:00 Author:muriel | Keyword: Fuse, Monitor, Indicator
The idea for this project may have come to me in a flash of inspiration, and its a very simple way to check if a fuse has blown without removing it from its holder. (View)
View full Circuit Diagram | Comments | Reading(745)
Published:2012/11/23 1:04:00 Author:muriel | Keyword: Regulated , 12 Volt, Supply
View full Circuit Diagram | Comments | Reading(1109)
Published:2012/11/23 1:03:00 Author:muriel | Keyword: 12 Volt , 30 Amp, Power Supply
Using a single 7812 IC voltage regulator and multiple outboard pass transistors, this power supply can deliver output load currents of up to 30 amps. (View)
View full Circuit Diagram | Comments | Reading(1760)
Published:2012/11/23 1:03:00 Author:muriel | Keyword: L200, Power Supply
Power supply with variable voltage and fixed current regulation made using the ubiquitous L200C regulator. (View)
View full Circuit Diagram | Comments | Reading(1747)
Published:2012/11/23 1:02:00 Author:muriel | Keyword: Gyrator Circuit
View full Circuit Diagram | Comments | Reading(0)
Published:2012/11/23 1:00:00 Author:muriel | Keyword: FM Stereo, Transmitter
This is a small stereo FM transmitter. Output can be tuned from 88to 108Mhz and the transmitter can be battery powered or be used with the low voltage power supply on this page. (View)
View full Circuit Diagram | Comments | Reading(2503)
Published:2012/11/23 0:59:00 Author:muriel | Keyword: MSF Receiver
This is an experimental 60khz direct conversion receiver for reception of the UK MSF Time Signal from Anthorn, Cumbria. (The mast array can be seen on the right hand image.) For continued stability, the radio should be continuously supplied from a +13.8v bench power supply.
To achieve enough rf signal pickup, an outside long wire aerial is required, of at least 25 feet anchored to a pole. No aerial balun must be used. (View)
View full Circuit Diagram | Comments | Reading(1864)
Published:2012/11/23 0:58:00 Author:muriel | Keyword: Tracking Transmitter
This is a small battery operated Tracking transmitter which broadcasts a repeating radio signal which can be detected by a directional antenna. The transmitter broadcasts an isotropic (radiates in all directions) signal on the FM band. An ordinary FM radio can be used to locate the transmitter, the reception of the signal will improve when the radio antenna is pointed in the direction of the transmitter. (View)
View full Circuit Diagram | Comments | Reading(1907)
Pages:262/2234 At 20261262263264265266267268269270271272273274275276277278279280Under 20 |