HV833, HV833MG/H833, HV839MG Selling Leads, Datasheet
MFG:HV Package Cooled:MSOP-8 D/C:04+

HV833, HV833MG/H833, HV839MG Datasheet download
Part Number: HV833
MFG: HV
Package Cooled: MSOP-8
D/C: 04+
MFG:HV Package Cooled:MSOP-8 D/C:04+
HV833, HV833MG/H833, HV839MG Datasheet download
MFG: HV
Package Cooled: MSOP-8
D/C: 04+
Want to post a buying lead? If you are not a member yet, please select the specific/related part number first and then fill the quantity and your contact details in the "Request for Quotation Form" on the left, and then click "Send RFQ".Your buying lead can then be posted, and the reliable suppliers will quote via our online message system or other channels soon.
TOP
PDF/DataSheet Download
Datasheet: HV833
File Size: 513100 KB
Manufacturer: SUTEX [Supertex, Inc]
Download : Click here to Download
PDF/DataSheet Download
Datasheet: HV803
File Size: 82657 KB
Manufacturer: SUTEX [Supertex, Inc]
Download : Click here to Download
PDF/DataSheet Download
Datasheet: HV839MG-G
File Size: 361342 KB
Manufacturer: SUTEX [Supertex, Inc]
Download : Click here to Download
The Supertex HV833 is a high voltage driver designed for driving EL lamps of up to 35nF (10-12in2). The input supply voltage range is from 1.8V to 6.5V. The device uses a single inductor and a minimum number of passive components. The nominal regulated output voltage that is applied to the EL lamp is ±90V. The chip can be enabled/disabled by connecting the resistor on R SW-OSC to VDD/ground.
The HV833 has two internal oscillators, a switching MOSFET, and a high voltage EL lamp driver. The frequency for the switching MOSFET is set by an external resistor connected between the R SW-osc pin and the supply pin VDD. The EL lamp driver frequency is set by an external resistor connected between R EL-osc pin and the VDD pin. An external inductor is connected between the LX and VDD or VIN pins. A 0.003-0.1F capacitor is connected between CS and ground. The EL lamp is connected between VA and VB.
The switching MOSFET charges the external inductor and discharges it into the capacitor at CS. The voltage at CS will start to increase. Once the voltage at CS reaches a nominal value of 90V, the switching MOSFET is turned OFF to conserve power. The outputs VA and VB are configured as an H bridge and are switching in opposite states to achieve 180V peak-to-peak across the EL lamp.
Response in 12 hours
© 2008-2012 SeekIC.com Corp.All Rights Reserved.