Photodiodes Photodiode
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Product : | PIN Photodiodes | Reverse Voltage : | 60 V |
Maximum Dark Current : | 60 nA | Peak Wavelength : | 850 nm |
Rise Time : | 5 ns | Fall Time : | 5 ns |
Package / Case : | Side Looker |
Re verse Break down Volt age . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .60 V
Storage and Op erating Tem perature Range . . . . . . . . . . . . -40 to +100
Lead Sol dering Tem perature
[1/16 inch (1.6 mm) from case for 5 sec. with sol deringiron] . . . . . . . 260(1)
Power Dis sipation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .00 mW(2)
Notes:
(1) RMA flux is recommended. Duration can be extended to 10 sec. max. when flow soldering. Max. 20 grams force may be applied to leads when soldering.
(2) Derate linearly 1.67 mW/ above 25.
(3) Light source is an unfiltered GaAs LED with a peak emission wavelength of 935nm and a radiometric intensity level which varies less than 10% over the entire lens surface of the photodiode being tested.
(4) To calculate typical dark current in mA, use the formula ID = 10(0.042 TA-1.5) where TA is ambient temperature in
The OP954 device consists of a PIN silicon photodiode molded in a clear epoxy package which allows spectral response from visible to infrared light wavelengths. The very wide receiving angle provides relatively even reception over a large area. The side-looking package is designed for easy PC board mounting. These devices are 100% production tested using infrared light for close correlation with Optek's GaAs and GaAlAs emitters.
Technical/Catalog Information | OP954 |
Vendor | TT Electronics/Optek Technology |
Category | Sensors, Transducers |
Lead Free Status | Lead Free |
RoHS Status | RoHS Compliant |
Other Names | OP954 OP954 |