HIP0082ABT

The HIP0082ABT belongs to HIP0082 quad power drivers family which contain four individually protected NDMOS transistor switches to drive inductive and resistive loads such as: fuel injectors, relays, solenoids, etc. Diagnostic circuits provide ground short (SG), supply short (SC) and open load (OL) detection for each of the four output stages and indicate over temperature. The outputs are low-side switches driven by active-low CMOS logic inputs. Each output is protected against excessive current due to a short-circuit. HIP0082ABT are fabricated in a Power BiMOS IC process and are intended for use in automotive and other applications with a wide range of temperature and electrical stress. Internal drain-to-gate zener diodes provide output clamping for over voltage. An integrated charge pump allows operation from a single 5V logic supply. HIP0082ABT are particularly suited for driving high-current inductive loads requiring high breakdown voltage and high output current. Both types available in the 15 lead Power SIP or 20 lead PSOP packages with low thermal resistance for high power applications. Diagnostic information may be read via a synchronous serial interface. Six bits of write/store data sets a long or short OL fault delay time for each output and sets Outputs 3 and 4 to a 2A or 5A current shutdown threshold.

The features of HIP0082ABT can be summarized as (1)low side power MOSFET output drivers - output voltage clamp (Typ): 80V - maximum output current: 5A/2A - output rDS(ON) (TJ = 150°C) (Max) : 0.57/0.62; (2)controlled slew rate switching (HIP0084); (3)single pulse energy rating : 70mJ; (4)programmable output over current shutdown threshold - bit select 2A or 5A on outputs 3 and 4; (5)output protection - output over current shutdown - output over voltage clamp - over temperature diagnostic feedback; (6)diagnostics for shorts, opens and over temperature; (7)synchronous serial interface with - 22-Bit serial diagnostic register - SPI compatible interface; (8)single 5V supply operation with CMOS logic inputs; (9)supply current, ICC, full load (Typ) : <10mA; (10)low JC Power SIP Packages SIP : 3°C/W PSOP : 2°C/W; (11)-40°C to 125°C operating temperature.

The absolute maximum ratings of HIP0082ABT are (1)supply voltage (logic and control), VCC: -0.3V to 7V; (2)power MOSFET drain voltage, VO (Note 3): -0.7 to VCLAMP; (3)output clamp energy, EOK (See Note 5): 70mJ; (4)input voltage (logic and driver inputs), VIN: -0.5V to VCC +0.5V; (5)maximum output current, outputs 1 and 2: +2A; (6)maximum output current, outputs 3 and 4: +5A; (7)maximum total output current, all outputs ON: +8A; (8)maximum peak output current, IO(MAX), (Note 4) : -5A to ISC.