Features: • ACT4418 Dual Transceivers meets MIL-STD-1553A&B, Macair A3818, A4905, A5232 and A5690 Specs• ±12 Volt Power Supply Operation• Voltage source output for higher bus drive power• Molded Plug-in package• Monolithic construction using linear ASICs• Va...
ACT4418: Features: • ACT4418 Dual Transceivers meets MIL-STD-1553A&B, Macair A3818, A4905, A5232 and A5690 Specs• ±12 Volt Power Supply Operation• Voltage source output for higher bus d...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Operating case temperature |
-40°C to +85°C | |
Storage case temperature |
-65°C to +150°C | |
Power supply Voltages |
±12 V P.S. to ±15V MAX |
+5 V P.S. to +7V MAX |
Logic input voltage |
-0.3 V to +5.5 V | |
Receiver differential input |
±40 V | |
Receiver input voltage (common mode) |
±10 V | |
Transmitter peak output current |
110 mA | |
Total package power dissipation over the full operating case temperature range (100% duty cycle) |
1.65 Watts | |
TJ Maximum |
150°C | |
Maximum junction to case temperature (100 % duty cycle) |
60°C | |
Maximum Junction-Air thermal resistance for free air |
36°C/W |
The Aeroflex Circuit Technology ACT4418D is a new generation monolithic transceivers which provide full compliance with Macair and MILSTD- 1553 data bus requirements while providing variable amplitude control.
The ACT4418D performs the frontend analog function of inputting and outputting data through a transformer to a MIL-STD-1553 or Macair data bus. The ACT4418D can be considered a "Universal" Transceiver in that it is compatible with MIL-STD-1553A, B, Macair A-3818, A-4905, A-5232 and A-5690.
Design of these transceivers reflects particular attention to active filter performance.This results in low bit and word error rate with superior waveform purity and minimal zero crossover distortion. The ACT4418D active filter design has additional high frequency roll-off to provide the required Macair low harmonic distortion waveform without increasing the pulse delay characteristics significantly.
Efficient transmitter electrical and thermal design of ACT4418 provides low internal power dissipation and heat rise at high and well as low duty cycles.
Variable amplitude of ACT4418 is adjusted with 010 Vdc on the control pin.