Features: • On-chip address counter, incremented by each rising edge on the clock input• Simple interface to the FPGA; requires only one user I/O pin• Cascadable for storing longer or multiple bitstreams• Programmable reset polarity (active High or active Low) for compatibi...
XC1701L: Features: • On-chip address counter, incremented by each rising edge on the clock input• Simple interface to the FPGA; requires only one user I/O pin• Cascadable for storing longer...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Symbol | Description | Units | |
VCC | Supply voltage relative to GND | -0.5 to +7.0 | V |
VPP | Supply voltage relative to GND | -0.5 to +12.5 | V |
VIN | Input voltage relative to GND | -0.5 to VCC +0.5 | V |
VTS | Voltage applied to 3-state output | -0.5 to VCC +0.5 | V |
TSTG | Storage temperature (ambient) | -65 to +150 | °C |
TSOL | Maximum soldering temperature (10 s @ 1/16 in.) | +260 | °C |
Note: Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those listed under Operating Conditions is not implied. Exposure to Absolute Maximum Ratings conditions for extended periods of time may affect device reliability.
The XC1701L, XC1701 and XC17512L serial configuration PROMs (SCPs) provide an easy-to-use, cost-effective method for storing Xilinx FPGA configuration bitstreams.
When the XC1701L, XC1701 and XC17512L FPGA is in master serial mode, it generates a configuration clock that drives the SCP. A short access time after the rising clock edge, data appears on the SCP DATA output pin that is connected to the FPGA DIN pin. The FPGA generates the appropriate number of clock pulses to complete the configuration. Once configured, it disables the SCP. When the FPGA is in slave mode, the SCP and the FPGA must both be clocked by an incoming signal.
Multiple XC1701L, XC1701 and XC17512L devices can be concatenated by using the CEO output to drive the CE input of the following device. The clock inputs and the DATA outputs of all SCPs in this chain are interconnected. All devices are compatible and can be cascaded with other members of the family.For device programming, either the Xilinx Alliance or Foundation series development system compiles the FPGA design file into a standard Hex format, which is then transferred to the programmer.