Features: ` 14-bit ADC` No missing codes guaranteed` 6MSPS conversion rate` Low power 250mW typical` 5V single supply or 5V/3.3V dual supply operation` Single or 3 channel operation` Correlated double sampling` Programmable gain (8-bit resolution)` Programmable offset adjust (8-bit resolution)` P...
WM8190: Features: ` 14-bit ADC` No missing codes guaranteed` 6MSPS conversion rate` Low power 250mW typical` 5V single supply or 5V/3.3V dual supply operation` Single or 3 channel operation` Correlated dou...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
CONDITION | MIN | MAX |
Digital supply voltage: DVDD | GND - 0.3V | GND + 7V |
Analogue supply voltage: AVDD | GND - 0.3V | GND + 7V |
Digital ground: DGND. Analogue ground: AGND1, AGND2 | GND - 0.3V | GND + 0.3V |
Digital inputs: MCLK, VSMP, CLAMP | GND - 0.3V | GND + 0.3V |
Digital outputs: DOUT | GND - 0.3V | DVDD2 + 0.3V |
Analogue inputs: VINM, VINP, VREFIN | GND - 0.3V | AVDD + 0.3V |
Reference pins: VRT, VRB | GND - 0.3V | AVDD + 0.3V |
Operating temperature range: TA | 0°C | +70°C |
Storage temperature | -65°C | +150°C |
Package body temperature (soldering, 10 seconds) | +240°C | |
Package body temperature (soldering, 2 minutes) | +183°C |
The WM8190 is a 14-bit analogue front end/digitiser ICwhich processes and digitises the analogue output signalsfrom CCD sensors or Contact Image Sensors (CIS) at pixelsample rates of up to 6MSPS.
The WM8190 includes three analogue signal processingchannels each of which contains Reset Level Clamping,Correlated Double Sampling and Programmable Gain andOffset adjust functions. Three multiplexers allow singlechannel processing. The output from each of thesechannels is time multiplexed into a single high-speed 14-bitAnalogue to Digital Converter. The digital output data isavailable in 8, 7 or 4-bit wide multiplexed format, with nomissing codes.
An internal 4-bit DAC of the WM8190 is supplied for internal reference levelgeneration. This may be used during CDS to reference CISsignals or during Reset Level Clamping to clamp CCDsignals. An external reference level may also be supplied.ADC references are generated internally, ensuring optimumperformance from the device.
Using an analogue supply voltage of 5V and a digitalinterface supply of either 5V or 3.3V, the WM8190 typicallyonly consumes 250mW when operating from a single5V supply.