WF512K32N-XH1X5

Features:

· Access Times of 60, 70, 90, 120, 150ns
· Packaging
    • 66 pin, PGA Type, 1.075" square, Hermetic Ceramic HIP (Package 400(1)).
    • 68 lead, 40mm, Low Capacitance Hermetic CQFP (Package 501)1
    • 68 lead, 40mm, Low Profi le 3.5mm (0.140"), CQFP (Package 502)1
    • 68 lead, 22.4mm (0.880") Low Profi le CQFP (G2U) 3.5mm (0.140") high, (Package 510)1
    • 68 lead, 22.4mm (0.880") CQFP (G2L) 5.08mm (0.200") high, Package (528)
· 1,000,000 Erase/Program Cycles Minimum
· Sector Architecture
    • 8 equal size sectors of 64KBytes each
    • Any combination of sectors can be concurrently erased. Also supports full chip erase
· Organized as 512Kx32
· Commercial, Industrial and Military Temperature Ranges
· 5 Volt Programming. 5V ± 10% Supply.
· Low Power CMOS, 6.5mA Standby
· Embedded Erase and Program Algorithms
· TTL Compatible Inputs and CMOS Outputs
· Built-in Decoupling Caps for Low Noise Operation
· Page Program Operation and Internal Program Control Time
· Weight
    WF512K32 - XG2UX5 - 8 grams typical
    WF512K32N - XH1X5 - 13 grams typical
    WF512K32 - XG4TX51 - 20 grams typical
    WF512K32-XG2LX5 - 8 grams typical



Pinout




Specifications

Parameter		Unit
Operating Temperature	-55 to +125
Supply Voltage Range (VCC)	-2.0 to +7.0	V
Signal voltage range (any pin except A9) (2)	-2.0 to +7.0	V
Storage Temperature Range	-65 to +150
Lead Temperature (soldering, 10 seconds)	+300
Data Retention (Mil Temp)	20 years
Endurance - write/erase cycles (Mil Temp)	1,000,000 cycles min.
A9 Voltage for sector protect (VID) (3)	-2.0 to +14.0	V

NOTES:
1. Stresses above the absolute maximum rating may cause permanent damage to the device. Extended
    operation  at the maximum levels may degrade performance and affect reliability.
2. Minimum DC voltage on input or I/O pins is -0.5V. During voltage transitions,inputs may overshoot Vss to -
    2.0 V for periods of up to 20ns. Maximum DC voltage on output and I/O pins is Vcc + 0.5V. During
    voltage  transitions, outputs may overshoot to Vcc + 2.0 V for periods of up to 20ns.
3. Minimum DC input voltage on A9 pin is -0.5V. During voltage transitions, A9 may overshoot Vss to -2V for
    periods of up to 20ns. Maximum DC input voltage on A9 is +13.5V which may overshoot to 14.0 V for periods
    up to 20ns.