DescriptionThe TPD2002F is a kind of intelligent power device for a 2-channel squib driver for use with SRS electronic air bags. The device is based on the Bi-CMOS-DMOS process. There are some features of TPD2002F as follows: (1)four independent inputs to control two high-side and two low-side sw...
TPD2002F: DescriptionThe TPD2002F is a kind of intelligent power device for a 2-channel squib driver for use with SRS electronic air bags. The device is based on the Bi-CMOS-DMOS process. There are some feat...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
US $6.66 - 7.56 / Piece
Power Switch ICs - Power Distribution Pd 0.8W RDS 1.2Ohm 8-Circuit High Side
The TPD2002F is a kind of intelligent power device for a 2-channel squib driver for use with SRS electronic air bags. The device is based on the Bi-CMOS-DMOS process.
There are some features of TPD2002F as follows: (1)four independent inputs to control two high-side and two low-side switches, driving two squibs directly; (2)the following diagnosis functions (analog multiplexer outputs) are built in:; (3)squib short-to-battery diagnosis, squib short-to-ground diagnosis, squib open-circuit diagnosis, safing sensor-on diagnosis, squib short diagnosis, squib drive MOSFET diagnosis; (4)built-in protection for overheating; (5)24-pin SSOP surface mount package; (6)supports embossed taping.
The following is about the maximum ratings of TPD2002F (Ta=-40 to 85): (1)power supply voltage, VPS: 30 V; (2)power supply voltage, VCC: 7 V; (3)input voltage (for control), VIN -0.5 to 7 V; (4)backup capacitor capacitance, CM: 1500F (25 V); (5)squib on-time, tON: 30 ms; (6)power dissipation, PD: 0.8 W; (7)operating temperature, Topr -40 to 85; (8)junction temperature, Tj: 150; (9)storage temperature, Tstg: -55 to 150.
The last one is about the electrical characteristics of TPD2002F(VPS=6 to 25 V, VCC=5±0.25 V, Ta=-40 to 85): (1)operating voltage, VPS: 6 V min and 25 V max ; (2)operating voltage, VCC: 4.75 V min and 5.25 V max ; (3)input voltage, VIL, input "L": 1.5 V max; (4)input voltage, VIH, input "H": 3.5 V min; (5)input current, IIL: ±10A max at VIN=VCC (pulled-ip pin), VIN=0 V (pull-down pin); (6)input current, IIH: 50A typ and 200A max at VIN=VCC (pulled-ip pin), VIN=0 V (pull-down pin); (7)high-side driver output leakage current, IOLH: 100A max at VOUT=25 V; (8)low-side driver output leakage current, IOLL: 100A max at VOUT=25 V; (9)amp saturation voltage, VAMPSAT: 3.75 V min at VCC=4.75 V, IAO=5A.