PIC18F8410

Features:

• C compiler optimized architecture:
- Optional extended instruction set designed to optimize re-entrant code
• 1000 erase/write cycle Flash program memory typical
• Flash Retention: 100 years typical
• Priority levels for interrupts
• 8 x 8 Single-Cycle Hardware Multiplier
• Extended Watchdog Timer (WDT):
- Programmable period from 4 ms to 131s
- 2% stability over VDD and temperature
• In-Circuit Serial Programming™ (ICSP™) via two pins
• In-Circuit Debug (ICD) via two pins
• Wide operating voltage range: 2.0V to 5.5V

Specifications

Parameter Name	Value
Program Memory Type	Flash
Program Memory (KB)	16
CPU Speed (MIPS)	10
RAM Bytes	768
Digital Communication Peripherals	2-A/E/USART, 1-MSSP(SPI/I2C)
Capture/Compare/PWM Peripherals	3 CCP
Timers	2 x 8-bit, 3 x 16-bit
ADC	12 ch, 10-bit
Comparators	2
Temperature Range (C)	-40 to 125
Operating Voltage Range (V)	2 to 5.5
Pin Count	80

Absolute Maximum Ratings(†)
Ambient temperature under bias...............................................................-40°C to +125°C
Storage temperature .............................................................................. -65°C to +150°C
Voltage on any pin with respect to V_SS (except V_DD, MCLR and RA4)...-0.3V to (V_DD + 0.3V)
Voltage on V_DD with respect to V_SS ............................................................... -0.3V to +7.5V
Voltage onMCLR with respect to V_SS (Note 2) ............................................... 0V to +13.25V
Voltage on RA4 with respect to Vss .................................................................... 0V to +8.5V
Total power dissipation (Note 1) .....................................................................................1.0W
Maximum current out of V_SS pin ..................................................................................300 mA
Maximum current into V_DD pin .....................................................................................250 mA
Input clamp current, I_IK (V_I < 0 or V_I > V_DD)............................................................. ±20 mA
Output clamp current, I_OK (V_O < 0 or V_O > V_DD) ...................................................... ±20 mA
Maximum output current sunk by any I/O pin.................................................................25 mA
Maximum output current sourced by any I/O pin ...........................................................25 mA
Maximum current sunk by all ports ..............................................................................200 mA
Maximum current sourced by all ports ..........................................................................200 mA

Note 1: Power dissipation is calculated as follows:
Pdis = V_DD x {I_DD I_OH} + {(V_DD V_OH) x I_OH} + (V_OL x I_OL)
2: Voltage spikes below VSS at the MCLR/VPP pin, inducing currents greater than 80 mA, may cause latch-up. Thus, a series resistor of 50-100 should be used when applying a "low" level to the MCLR/V_PP pin, rather than pulling this pin directly to V_SS.
† NOTICE: Stresses above those listed under "Absolute Maximum Ratings" may cause permanent damage to the
device. This is a stress rating only and functional operation of the device at those or any other conditions above those
indicated in the operation listings of this specification is not implied. Exposure to maximum rating conditions for
extended periods may affect device reliability.

Description

PIC18F8410 Microcontroller with 16K bytes of Flash and 768 bytes of RAM. The PIC18F8410 features make it ideal for manufacturing equipment, instrumentation and monitoring, data acquisition, power conditioning, environmental monitoring, telecom and consumer applications.