PI74FCT153T/253T

• PI74FCT153T/253T/2153T/2253T is pin compatible withbipolar FAST™ Series at a higher speed and lower powerconsumption
• 25W series resistor on all outputs ( FCT2XXX only)
• TTL input and output levels
• Low ground bounce outputs (25W series only)
• Extremely low static power
• Hysteresis on all inputs
• Industrial operating temperature range: 40°C to +85°C
• Packages available: 16-pin 150 mil wide plastic QSOP (Q) 16-pin 300 mil wide plastic SOIC (S)  16-pin 150 mil wide plastic SOIC (W)

Storage Temperature .................................................................... 65°C to +150°C
Ambient Temperature with Power Applied .................................... 40°C to +85°C
Supply Voltage to Ground Potential (Inputs & Vcc Only) .............. 0.5V to +7.0V
Supply Voltage to Ground Potential (Outputs & D/O Only) ........... 0.5V to +7.0V
DC Input Voltage ............................................................................ 0.5V to +7.0V
DC Output Current ..................................................................................... 120 mA
Power Dissipation ..........................................................................................0.5W

Note:
Stresses greater than those listed under MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability.

Pericom Semiconductor's PI74FCT series of logic circuits are producedin the Company's advanced 0.8 micron CMOS technology,achieving industry leading speed grades. All PI74FCT2XXX deviceshave a built-in 25-ohm series resistor on all outputs to reduce noiseresulting from reflections, thus eliminating the need for an externalterminating resistor.

The PI74FCT153T/253T and PI74FCT2153T/2253T are highspeeddual 4-input multiplexers. The PI74FCT153T/2153T hasTTL outputs, while the PI74FCT253T/2253T has 3-state outputs.The output buffers are designed with a power-off disable allowing"live insertion" of boards when used as backplane drivers.