Features: ` WIDEBAND +5V OPERATION: 225MHz (G = +2)` UNITY GAIN STABLE: 280MHz (G = 1)` HIGH OUTPUT CURRENT: 150mA` OUTPUT VOLTAGE SWING: ±4.0V` HIGH SLEW RATE: 2100V/ms` LOW SUPPLY CURRENT: 6mA/ch` LOW DISABLED CURRENT: 200A/ch` ENABLE/DISABLE TIME: 25ns/100nsApplication· xDSL LINE DRIVER· MATCHE...
OPA2681: Features: ` WIDEBAND +5V OPERATION: 225MHz (G = +2)` UNITY GAIN STABLE: 280MHz (G = 1)` HIGH OUTPUT CURRENT: 150mA` OUTPUT VOLTAGE SWING: ±4.0V` HIGH SLEW RATE: 2100V/ms` LOW SUPPLY CURRENT: 6mA/ch`...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
US $.62 - .64 / Piece
Operational Amplifiers - Op Amps 2.2nV/rtHz,18MHz, Prec,RRO,36V Op Amp
The OPA2681 sets a new level of performance for broadband dual current feedback op amps. Operating on a very low 6mA/ch supply current, the OPA2681 offers a slew rate and output power normally associated with a much higher supply current. A new output stage architecture delivers a high output current with minimal voltage headroom and crossover distortion. This gives exceptional single supply operation. Using a single +5V supply, the OPA2681 can deliver a 1V to 4V output swing with over 100mA drive current and 150MHz bandwidth. This combination of features makes the OPA2681 an ideal RGB line driver or single supply ADC input driver.
The OPA2681's low 6mA/ch supply current is precisely trimmed at 25. This trim, along with low drift over temperature, guarantees lower guaranteed maximum supply current than competing products. System power may be further reduced by using the optional disable control pin (SO-14 only). Leaving this disable pin open, or holding it high, gives normal operation. If pulled low, the OPA2681 supply current drops to less than 400mA while the output goes into a high impedance state. This feature may be used for either power savings or for video MUX applications.