Features: • Low Noise. . . . . . . . . . . . . . . . . . . . . . . . . .. . . 4.3nV/Hz
• Bandwidth. . . . . . . . . . . . . . . . . . . . 8MHz (Compensated)
60MHz (Uncompensated)
• Slew Rate . . . . . . . . . . . . . . . . . . . . 3V/s (Compensated)
20V/s (Uncompensated)
• Low Offset Voltage . . . . . . . . . . . . . . . . . . . . . . . . . 0.5mV
• Available in Duals or QuadsApplication• High Q, Active Filters
• Audio Amplifiers
• Instrumentation Amplifiers
• Integrators
• Signal Generators
• For Further Design Ideas, See Application Note AN554Pinout
SpecificationsSupply Voltage Between V+ and V- Terminals. . . . . . . . . . . . . . 40V
Differential Input Voltage . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . 7V
Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . ±VSUPPLY
Output Short Circuit Duration (Note 3). . . . . . . . . . . . . . . . Indefinite
CAUTION: Stresses above those listed in "Absolute Maximum Ratings" may cause permanent damage to the device. This is a stress only rating and operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
1. Maximum power dissipation, including output load, must be designed to maintain the maximum junction temperature below 175 for hermetic packages, and below 150 for plastic packages.
2. JA is measured with the component mounted on an evaluation PC board in free air.
3. Any one amplifier may be shorted to ground indefinitely.DescriptionLow noise and high performance are key words describing HA-5102, HA-5104 and HA-5114. These general purpose amplifiers offer an array of dynamic specifications ranging from a 3V/s slew rate and 8MHz bandwidth (5102/04) to 20V/s slew rate and 60MHz gain-bandwidth-product (HA-5114). Complementing these outstanding parameters is a very low noise specification of 4.3nV/Hz at 1kHz.
Fabricated using the Intersil high frequency DI process, these HA-5102, HA-5104 and HA-5114 operational amplifiers also offer excellent input specifications such as a 0.5mV offset voltage and 30nA offset current. Complementing these specifications are 108dB open loop gain and 60dB channel separation. Consuming a very modest amount of power (90mW/ package for duals and 150mW/package for quads), HA- 5102/04/14 also provide 15mA of output current.
This impressive combination of features make HA-5102, HA-5104 and HA-5114 amplifiers ideally suited for designs ranging from audio amplifiers and active filters to the most demanding signal conditioning and instrumentation circuits.
These HA-5102, HA-5104 and HA-5114 operational amplifiers are available in dual or quad form with industry standard pinouts allowing for immediate interchangeability with most other dual and quad operational amplifiers.HA-5102 Dual, Comp. HA-5104 Quad, Comp.HA-5114 Quad, Uncomp.Refer to the /883 data sheet for military product.
HA-5102 Data Sheet
