Features: • Typical POUT of 28.5 dBm• High linearity• Low power consumption• Single +5 V supply• LCC (8-pin, 8 x 8 mm) packageApplication• PCS/DCS/UMTS• Repeaters• WLL and ISM bands• Mobile radio• TelematicsPinoutSpecifications Par...
CX65105: Features: • Typical POUT of 28.5 dBm• High linearity• Low power consumption• Single +5 V supply• LCC (8-pin, 8 x 8 mm) packageApplication• PCS/DCS/UMTS• Rep...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Parameter | Symbol | Min | Typical | Max | Units |
RF input power | PIN | 7 | dBm | ||
Supply voltage | VCC | 6 | V | ||
Reference voltage | VREF | 4 | V | ||
Case operating temperature | TC | 40 | +85 | ||
Storage temperature | TST | 55 | +125 |
Note: Exposure to maximum rating conditions for extended periods may reduce device reliability. There is no damage to device with only one parameter set at the limit and all other parameters set at or below their nominal values.
Skyworks CX65105 Power Amplifier (PA) is a fully matched, 8-pin Leadless Chip Carrier (LCC) surface mount module, developed for Personal Communications System (PCS), Digital Communications System (DCS), and Universal Mobile Telephone System (UMTS) applications. Wireless Local Loop (WLL) and Industrial, Scientific, Medical (ISM) applications are also supported. This small, power-efficient PA has a full 1700 to 2200 MHz bandwidth coverage packed into a single compact package. All active circuitry in the module is contained in a single Gallium Arsenide (GaAs) Microwave Monolithic Integrated Circuit (MMIC).
The CX65105 is manufactured with Skyworks Aluminum (Al) GaAs Heterojunction Bipolar Transistor (HBT) process, which allows for single supply operation while maintaining high efficiency and good linearity.
The 8-pin Leadless Chip Carrier (LCC) device package and pinout are shown in Figure 1. Figure 2 shows a functional block diagram for the CX65105. Signal pin assignments and functional pin descriptions are provided in Table 1.