Features: • Gain = 32 37 dB from 950 2150 MHz (positive gain slope) • Low Power Consumption: 40mA at +5.0 Volts • Exceptionally low Noise Figure: less than 3 dB • Low Cost, Low Parts Count • High Reverse Isolation • Output Compression point: +1 dBm minimum (M...
BGA430: Features: • Gain = 32 37 dB from 950 2150 MHz (positive gain slope) • Low Power Consumption: 40mA at +5.0 Volts • Exceptionally low Noise Figure: less than 3 dB • Low Cost,...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Infineon's BGA430 Broad Band High Gain Low Noise Amplifier and BGB540 Active Biased Transistor are shown in an Intermediate-Frequency ("I.F.") amplifier application targeted for the I.F. chains of European, Asian and North American Direct-Broadcast Satellite (DBS) Low Noise Block Amplifier / Downconverters (LNBs).
A summary of key performance parameters for the complete LNB I.F. Amplifier is given in Table 1 to the right. The reader is referred to Appendix A on page 21 for complete electrical data including minimum, maximum, mean value, nd standard deviation for the lot of Printed Circuit Boards (PCBs) tested. Appendix B on page 22 gives information on performance over the 40 to +85 °C temperature range.
Section 2 of this applications note provides a brief description of BGA430 and BGB540 MMICs. Section 3 gives some general Direct Broadcast Satellite system information, and is included to provide a general background. Section 4 provides details on the PC Board used, including photos, a Bill of Material (BOM) and a PCB cross-sectional diagram. Section 5 describes using it as a stand-alone DBS I.F. Amplifier block, and covers design issues unique to BGA430. Section 6 addresses the question "why might one want a positive gain slope I.F. Amplifier" and Section 7 gives measurement results on the complete gain-sloped amplifier using both BGA430 & BGB540.