Features: ` Two Regulated Voltages and REF_OUT- Synchronous Buck Converter- Linear Regulator- REF_OUT = 0.8V±1% with 3mA source current` Single 12V Power Supply Required` Excellent Both Output Voltage Regulation- 0.8V Internal Reference- ±1% Over Line Voltage and Temperature` Integrated Soft-Start...
APW7068: Features: ` Two Regulated Voltages and REF_OUT- Synchronous Buck Converter- Linear Regulator- REF_OUT = 0.8V±1% with 3mA source current` Single 12V Power Supply Required` Excellent Both Output Volta...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Symbol | Parameter | Rating | Unit |
VCC12 | VCC12 to GND | -0.3 to +16 | V |
BOOT | BOOT to PHASE | -0.3 to +16 | V |
UGATE | UGATE to PHASE <400ns pulse width >400ns pulse width |
-5 to BOOT+5 -0.3 to BOOT+0.3 |
V |
LGATE | LGATE to PGND <400ns pulse width >400ns pulse width |
-5 to VCC12+5 -0.3 to VCC12+0.3 |
V |
PHASE | PHASE to GND <400ns pulse width >400ns pulse width |
-5 to +21 -0.3 to 16 |
V |
DRIVE | DRIVE to GND | 12 | V |
FB, FBL, COMP, FS_DIS |
FB, FBL, COMP, FS_DIS to GND | -0.3 to 7 | V |
The APW7068 integrates synchronous buck PWM, linear controller, and 0.8V Reference Out Voltage, as well as the monitoring and protection functions into a single package. The fixed 300KHz switching frequency synchronous PWM controller drives dual N-channel MOSFETs, which provides one controlled power output with over-voltage and over-current protections. Linear controller drives an external N-channel MOSFET with under-voltage protection.
The APW7068 provides excellent regulation for output load variation. An internal 0.8V temperaturecompensated reference voltage is designed to meet the requirement of low output voltage applications.
The APW7068 with excellent protection functions: POR, OCP, OVP and UVP. The Power-On Reset (POR) circuit can monitor VCC12 supply voltage exceeds its threshold voltage while the controller is running, and a built-in digital soft-start provides both outputs with controlled rising voltage. The Over-Current Protection (OCP) monitors the output current by using the voltage drop across the lower MOSFET's RDS(ON), comparing with the voltage of OCSET pin. When the output current reaches the trip point, the controller will shutdown the IC directly, and latch the converter's output. The Under-Voltage Protection (UVP) monitors the voltage of FBL pin for short-circuit protection. When the VFBL is less than 50% of VREF, the controller will shutdown the IC directly. The Over-Voltage Protection (OVP) monitors the voltage of FB. When the VFB is over 135% of VREF, the controller will make Lowside gate signal fully turn on until the fault events are removed.