Features: · 5 V tolerant inputs/outputs for interfacing with 5 V· Wide supply voltage range of 1.2 to 3.6 V· Complies with JEDEC standard no. 8-1A· CMOS low power consumption· MULTIBYTEä flow-trough standard pin-out architecture· Low inductance multiple power and ground pins for minimum noise...
74LVC322245A: Features: · 5 V tolerant inputs/outputs for interfacing with 5 V· Wide supply voltage range of 1.2 to 3.6 V· Complies with JEDEC standard no. 8-1A· CMOS low power consumption· MULTIBYTEä flow-t...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Symbol |
Parameter |
CONDITIONS |
Min |
Max |
Unit |
VCC |
DC Supply Voltage |
-0.5 |
+6.5 |
V | |
VI |
DC input voltage |
note 1 |
-0.5 |
+6.5 |
V |
IIK |
DC input diode current |
VI < 0 |
-50 |
mA | |
IOK |
DC output diode current |
VO > VCC or VO < 0; note 1 |
±50 |
mA | |
VO |
output voltage |
output HIGH or LOW state; note 1 |
-0.5 |
VCC + 0.5 |
V |
output 3-state; note 1 |
-0.5 |
+6.5 |
V | ||
IO |
DC output source or sink current |
VO = 0 to VCC |
±50 |
mA | |
ICC or IGND |
DC VCC or GND current |
±100 |
mA | ||
Tstg |
Storage temperature |
-65 |
+150 |
||
Ptot |
power dissipation |
temperature range -40 to +85 °C; note 2 |
1000 |
mW |
The 74LVC322245A is a high-performance, low-power, low-voltage, Si-gate CMOS device, superior to most advanced CMOS compatible TTL families. Inputs can be driven from either 3.3 or 5 V devices. In 3-state operation, outputs can handle 5 V. These features allow the use of these devices in a mixed 3.3 and 5 V environment.
The 74LVC322245A is a 32-bit transceiver featuring non-inverting 3-state bus compatible outputs in both send and receive directions. The 74LVC(H)322245A features
two output enable (nOE) inputs for easy cascading and two send or receive (nDIR) inputs for direction control. nOE controls the outputs so that the buses are effectively
isolated. The 74LVC322245A is designed with 30 W series termination resistors in both HIGH and LOW output stages to reduce line noise.
To ensure the high-impedance state during power-up or power-down, input nOE should be tied to VCC through a pull-up resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
The 74LVC322245A bus hold data inputs eliminates the need for external pull-up resistors to hold unused or floating data inputs at a valid logic level (see Fig.2).