EL6257, EL6257CM, EL6257CS Selling Leads, Datasheet
MFG:183 Package Cooled:N/A D/C:410
EL6257, EL6257CM, EL6257CS Datasheet download
Part Number: EL6257
MFG: 183
Package Cooled: N/A
D/C: 410
MFG:183 Package Cooled:N/A D/C:410
EL6257, EL6257CM, EL6257CS Datasheet download
MFG: 183
Package Cooled: N/A
D/C: 410
Want to post a buying lead? If you are not a member yet, please select the specific/related part number first and then fill the quantity and your contact details in the "Request for Quotation Form" on the left, and then click "Send RFQ".Your buying lead can then be posted, and the reliable suppliers will quote via our online message system or other channels soon.
TOP
PDF/DataSheet Download
Datasheet: EL6257
File Size: 137954 KB
Manufacturer: ELANTEC [Elantec Semiconductor]
Download : Click here to Download
PDF/DataSheet Download
Datasheet: EL6119
File Size: 23957 KB
Manufacturer: INTERSIL [Intersil Corporation]
Download : Click here to Download
PDF/DataSheet Download
Datasheet: EL6119
File Size: 23957 KB
Manufacturer: INTERSIL [Intersil Corporation]
Download : Click here to Download
The EL6257C is a high-performance four channel laser diode current amplifier that provides controlled current to a grounded laser diode.The four amplifiers can provide up to 150 mA per channel of DC or pulsed current. Channels 2, 3, and 4 must be used as the write chan-nels, with switching speeds of approximately one nanosecond rise/fall time. All four channels are summed together at the IOUT output, allow-ing the user to create multilevel waveforms in order to optimize laser diode performance. The level of the output current is set by an analog
voltage applied to an external resistor which converts the voltage into a current at the IIN pin (virtually ground). The current seen at this pin is then amplified by 100X to become a current source at pin IOUT.
An on-chip 500 MHz oscillator is provided to allow current modula-tion when in the read mode. This is turned on when the OSCEN pin isheld high (floating not recommended). Complete control of amplitude and frequency is set by two external resistors connected to ground at pins RFREQ and RAMP (see graphs in this data sheet for further explanation). The oscillator will also turn off whenever any of the OUTEN pins for channels 2, 3, and 4 (the write channels) are low (see truth table).
Output current pulses are enabled when an 'L' signal is applied to the OUTEN pin. No output current flows when OUTEN is 'H', and addi-tional laser diode protection is provided since the OUTEN input will float high when open. Complete IOUT shut-off is also achieved by holding the ENABLE pin low, which will override the OUTEN con-trol pins.
The external resistors allow the user to accurately and independently set each amplifier transconductance by applying a voltage to each resistor, without restriction on the voltage range, thus ensuring broad voltage DAC compatibility. Alternatively, the IIN pin can be biased from a current DAC or other current source.