Features: • Charges a 80F photoflash capacitor to 300V in 3.5 seconds from 3V• Charges various value photoflash capacitors• Over 75% flyback efficiency• Charge and Ready pins• Consumes only 4.5A when not charging• Small MSOP8 low profile packageApplicationR...
ZXSC440: Features: • Charges a 80F photoflash capacitor to 300V in 3.5 seconds from 3V• Charges various value photoflash capacitors• Over 75% flyback efficiency• Charge and Ready pin...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
US $.9 - 1.51 / Piece
Switching Converters, Regulators & Controllers Single Cell DC-DC
PARAMETER | LIMIT | UNIT |
VCC | -0.3 to +10 | V |
DRIVE | -0.3 to VCC + 0.3 | V |
READY | -0.3 to VCC + 0.3 | V |
CHARGE | -0.3 to The lower of (+5.0) or (VCC +0.3) | V |
VFB, SENSE | -0.3 to The lower of (+5.0) or (VCC +0.3) | V |
Operating temperature | -40 to +85 | °C |
Storage temperature | -55 to +150 | °C |
Power dissipation at 25°C | 450 | mW |
Part Number | ZXSC440 |
Type | Boost |
Min and Max Input Voltage (V) | 1.8 ~ 8 |
Output Voltage (V) | Vin to Vm |
Frequency (Hz) | 200K Fixed |
Efficiency (%) | 85 |
Standby Quiescent Current (uA) typ | 150 |
The ZXSC440 is a dedicated photoflash charger, charging an 80F photoflash capacitor to 300V in 3.5 seconds from a 3V supply.
The flyback conversion efficiency is typically 75%, much higher than the commonly used discrete charging circuits.
The Charge pin enables the circuit to be initiated from the camera's microprocessor, using negligible current when flash is not being used.
The Ready pin signals the microprocessor when the flash is charged and ready to be fired.
A small amount of hysteresis on the voltage feedback shuts down the device as long as the capacitor remains fully charged, again using negligible current.