Features: • Highly integrated mixer/oscillator PLL and IF AGC amplifier for multi band analog/digital terrestrial tuners and/or cable tuners• Low phase noise PLL frequency synthesizer• AGC output level detect with digital controlled TOP threshold• >50 dB Desired/Undesire...
ZL10060: Features: • Highly integrated mixer/oscillator PLL and IF AGC amplifier for multi band analog/digital terrestrial tuners and/or cable tuners• Low phase noise PLL frequency synthesizer...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
• Highly integrated mixer/oscillator PLL and IF AGC amplifier for multi band analog/digital terrestrial tuners and/or cable tuners
• Low phase noise PLL frequency synthesizer
• AGC output level detect with digital controlled TOP threshold
• >50 dB Desired/Undesired ratio without pre filtering
• Separate analog and digital IF outputs
• >41 dB IF AGC Control range
• Power down modes to support power reduction initiatives
• Four independent GPO
• 48 pin QFN Package
Characteristic | Min. | Max. | Units | Conditions |
Supply voltage | -0.3 | 6 | V | |
RF input voltage | 117 | dBV | Transient condition only | |
Maximum voltage on SDA, SCL | 5.5 | V | Vcc = 0 to 5.5V | |
Max voltage on all remaining signal pins | -0.3 | Vcc+0.3 | V | The voltage on any pin must not exceed 6 V |
Total port current | 20 | mA | ||
Storage temperature | -55 | 150 | ||
Junction temperature | 125 | Power applied | ||
Package thermal resistance (chip to ambient) |
27 | /W | Package paddle soldered to ground | |
ESD protection | 2.0 | kV | All pins except 9,10 | |
Mil-std 883B method 3015 cat1 | 1.25 | kV | Pins 9, 10 only |
The ZL10060 is a 3 band MOPLL with IF AGC amplifier. It down-converts the RF channel to a standard IF followed by filtering and IF AGC amplification for the digital channel. Each band consists of a low noise preamplifier/mixer and local oscillator with an external varactor tuned tank circuit.
An IF level detector, ZL10060 is included for control of the RF AGC. The Take Over Point and time constant are both programmable.
The ZL10060 has high signal level handling performance providing excellent performance in the presence of high level unwanted signals.
All chip control is via I2C bus.
If higher performance is required, an alternative part, ZL10060 is available with image reject down conversion.