XPS-2110WG

· Support 9.95 Gbps to 10.5 Gbps
· Complaint with XFP MSA
· Compliant to IEEE 802.3ae 10GBASE-LR/LW
· Compliant to 10GFC 1200-SM-LL-L
· Compliant with XFI 10G Serial Electrical Interface
· Maximum Link Length of 10 km
· Uncooled 1310 nm DFB LD
· 2-Wire Interface for Integrated Digital Diagnostic Monitoring
· No reference Clock required
· Only Required +3.3 V Power Supply
· Power Consumption < 2W
· RoHS Compliant
· -5 to 70oC Case Operating Temperature : XPS-2110WG
· -5 to 85oC Case Operating Temperature : XPS-2110BWG
· Duplex LC Connector

XPS-2110WG series transceiver is designed for single-mode fibre serial optical data communications such as 10G Ethernet 10GBASE-LR/LW and 10G Fibre Channel 1200-SM-LL-L.

The transceiver consists of two sections XPS-2110WG: The transmitter section consists of a directly modulated uncooled 1310 nm DFB laser, driver and signal conditioner. The receiver section incorporates a PIN photodiode integrated with a trans-impedance preamplifier (TIA) and signal conditioner.

The XPS-2110WG is with the XFP 30-pin connector to allow hot plug capability. Integrated Tx and Rx signal conditioners provide high jitter-tolerance for full XFI compliance and no external reference clock required. The internally ac coupled high speed serial I/O simplifies interfacing to external circuitry. Only single 3.3V power supply is needed. The optical output of XPS-2110WG can be disabled by LVTTL logic high-level input of TX_DIS. Loss of signal (RX_LOS) output is provided to indicate the loss of an input optical signal of receiver.

A serial EEPROM XPS-2110WG in the transceiver allows the user to access transceiver digital diagnostic monitoring and configuration data via the 2-wire XFP Management Interface. This interface uses a single address, A0h, with a memory map divided into a lower and upper area. Basic digital diagnostic data of XPS-2110WG is held in the lower area while specific data is held in a series of tables in the high memory area.