XPM-2100WG

·Support 9.95 Gbps to 10.5 Gbps
·Complaint with XFP MSA
·Compliant to IEEE 802.3ae 10GBASE
·Compliant to 10GFC
·Link Length up to 300 m with OM3 MMF
·Link Length up to 82 m with OM2 MMF
·Link Length up to 33 m with OM1 MMF
·850 nm VCSEL Transmitter
·2-Wire Interface for Integrated Digital Diagnostic Monitoring
·No reference clock required
·Low Power Dissipation < 1.2W
·Only Required +3.3 V Power Supply
·RoHS Compliant
·0 to 70oC Case Operating Temperature
·Duplex LC Connector

XPM-2100WG series multi-rate 10G XFP transceiver is designed for serial optical data communications such as 10 Gigabit Ethernet and 10G Fiber Channel. It supports the 10Gbps transmission on both 50/125 mm and 62.5/125 mm MMF.

The transceiver consists of two sections about XPM-2100WG: The transmitter section consists of a directly modulated 850 nm VCSEL, driver and signal conditioner. The receiver section incorporates a PIN photodiode integrated with a trans-impedance preamplifier (TIA) and signal conditioner.

The XPM-2100WG is with the XFP 30-pin connector to allow hot plug capability. Integrated Tx and Rx signal conditioners provide high jitter-tolerance for full XFI compliance and no external reference clock required. The internally ac coupled high speed serial I/O simplifies interfacing to external circuitry. Only single 3.3V power supply is needed. The optical output of XPM-2100WG can be disabled by LVTTL logic high-level input of TX_DIS. Loss of signal (RX_LOS) output is provided to indicate the loss of an input optical signal of receiver.

A serial EEPROM XPM-2100WG in the transceiver allows the user to access transceiver digital diagnostic monitoring and configuration data via the 2-wire XFP Management Interface. This interface uses a single address, A0h, with a memory map divided into a lower and upper area. Basic digital diagnostic data of XPM-2100WG is held in the lower area while specific data is held in a series of tables in the high memory area.