X9318WS8

Resistance (Ohms): 10k
Number of Circuits: 1
Mounting Type: Surface Mount
Memory Type: Non-Volatile
Package / Case: 8-SOIC (0.154", 3.90mm Width)
Packaging: Tube
Supplier Device Package: 8-SOIC
Series: XDCP™
Manufacturer: Intersil
Interface: 3-Wire Serial (Chip Select, Increment, Up/Down)
Temperature Coefficient: ±300 ppm/°C Typical
Voltage - Supply: 4.5 V ~ 5.5 V
Operating Temperature: 0°C ~ 70°C
Taps: 100


Features:

• Solid-state potentiometer
• 3-wire serial interface
• Terminal voltage, 0 to +8V
• 100 wiper tap points
  -Wiper position stored in nonvolatile memory and recalled on power-up
• 99 resistive elements
  -Temperature compensated
  -End to end resistance range ± 20%
•Low power CMOS
  -V_CC= 5V
  -Active current, 3mA max.
  -Standby current, 1mA max.
• High reliability
  -Endurance, 100,000 data changes per bit
  -Register data retention, 100 years
•R_TOTAL value = 10KΩ
•Packages
  -8-lead SOIC and DIP


Application

• LCD bias control
• DC bias adjustment
• Gain and offset trim
• Laser diode bias control
• Voltage regulator output control


Pinout




Specifications

Junction Temperature under bias ......65°C to +135°C
Storage temperature .........................65°C to +150°C
Voltage on CS, INC, U/D and V_CC
    with respect to V_SS .................................1V to +7V
R_H, R_W, R_L to ground ........................................... +10V
Lead temperature (soldering 10 seconds)..........300°C
I_W (10 seconds) ................................................. ±6mA


Description

The Xicor X9318 is a digitally controlled potentiometer (XDCP). The device consists of a resistor array, wiper switches, a control section, and nonvolatile memory. The wiper position is controlled by a 3-wire interface.

The X9318 potentiometer is implemented by a resistor array composed of 99 resistive elements and a wiper switching network. Between each element and at either end are tap points accessible to the wiper terminal. The position of the wiper element is controlled by the CS, U/D, and INC inputs. The position of the wiper can be stored in nonvolatile memory and then be recalled upon a subsequent power-up operation.

The X9318 can be used as a three-terminal potentiometer for voltage control or as a two-terminal variable resistor for current control in a wide variety of applications.