Features: · Runs with NE2000 TM or shared memory drivers· Supports up to 128 KB flash memory (8K/112K for attribute/common memory) or 512 bytes EEPROM (for attribute memory only) for nonvolatile memory· Uses one 16 KB SRAM or one 32 KB SRAM (if EEPROM is used) for 16 KB Ethernet ring buffer· Auto-...
W89C926: Features: · Runs with NE2000 TM or shared memory drivers· Supports up to 128 KB flash memory (8K/112K for attribute/common memory) or 512 bytes EEPROM (for attribute memory only) for nonvolatile mem...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
PARAMETER |
SYM. |
MINIMUM |
MAXIMUM |
UNIT |
Operating Temperature |
TA |
0 |
70 |
°C |
Storage Temperature |
TS |
-55 |
150 |
°C |
Supply Voltage |
VDD |
-0.5 |
7.0 |
V |
Input Voltage |
VIN |
VSS -0.5 |
VDD +0.5 |
V |
Output Voltage |
VOUT |
VSS -0.5 |
VDD +0.5 |
V |
Lead Temperature (soldering 10 seconds maximum) |
TL |
- |
250 |
°C |
ESD Tolerance | ESD |
2K |
- |
V |
The W89C926 PENTIC+ is a CMOS device designed for easy implementation of PCMCIA R2.1 compatible CSMA/CD local area networks. The W89C926 combines a W89C902 Serial LAN Coprocessor for Twisted-pair (SLCT) with a PCMCIA Bus Interface (PBI), thus integrating into a single chip all the registers and logic necessary to connect the SLCT to buffer SRAMs, flash memories (or an EEPROM), and the PCMCIA system bus.
The PCMCIA Bus Interface (PBI) W89C926 is designed to provide a switchless setting architecture that allows the card setting to be configured by software. It implements a full set of PCMCIA registers for PCMCIA R2.1 compatibility and a set of configuration registers for switchless card setting. The card can be configured quickly and easily by modifying the contents of the configuration registers. The PENTIC+ can run with shared memory mode and NE2000TM I/O mode drivers on a 16-bit bus interface. No extra effort is needed to ensure software compatibility.
The PENTIC+ W89C926 provides a flexible flash memory (up to 128 KB)/EEPROM (up to 512 bytes) architecture for PCMCIA nonvolatile storage and an ID/Configuration auto-load architecture for power-on initialization. Vendors can store the EthernetÒ ID, configuration, and CIS in the flash memory or EEPROM. The PENTIC+ will auto-load necessary information when power is switched on.