V23826-C18-C63/C363

ATM transceivers and matching circuits are high frequency components and shall be terminated as recommended in the application notes for proper EMI performance. Electromagnetic emission may be caused by these components.

To prevent emissions it is recommended that cutouts for the fiber connectors be designed as small as possible.

It is recommended that the Tx plug and the Rx plug be separated with a bar that divides the duplex SC opening.

Exceeding any one of these values may destroy the device
immediately.
Package Power Dissipation(1) .................................................................. 1.5 W
Supply Voltage (V_CCV_EE) 5 V....................................................................... 7 V
                                           3.3 V................................................................... 5 V
Data Input Levels................................................................................V_CC+0.5 V
Differential Data Input Voltage ................................................................... 2.5 V
Operating Ambient Temperature .........................................................0 to 70
Storage Ambient Temperature ...................................................... 40 to 85
Soldering Conditions Temp/Time (MIL-STD 883C, Method 2003) ........ 250/5.5s

Note
1. For V_CCV_EE (min., max.). 50% duty cycle. The supply current does not include the load drive current of
    the receiver output.

The Infineon single mode ATM transceiver complies with the ATM Forum's Network Compatible ATM for Local Network Applications document and ANSI's Broadband ISDN-Customer Installation Interfaces, Physical Media Dependent Specification, T1.646-1995, Bellcore - SONET OC-3 / IR-1 and ITU-T G. 957 STM-1 / S.1.1.

ATM was developed to facilitate solutions in multimedia applications and real time transmission. The data rate is scalable, and the ATM protocol is the basis of the broadband public networks being standardized in the International Telecommunications Union (ITU), the former International Telegraph and Telephone Consultative Committee (CCITT). ATM can also be used in local private applications.

The Infineon single mode ATM transceiver is a single unit comprised of a transmitter, a receiver, and an SC receptacle. This design frees the customer from many alignment and PC board layout concerns. The module is designed for low cost WAN applications. It can be used as the network end device interface in workstations, servers, and storage devices, and in a broad range of network devices such as bridges, routers, and intelligent hubs, as well as wide area ATM switches.

This ATM transceiver operates at 155.520 Mbit/s from a single power supply (+5 Volt or 3.3 Volt). The differential data inputs and outputs are PECL compatible.