Features: • Small Form Factor transceiver
• Multisource 2x5 footprint, SFF MSA compliant1)
• Small footprint for high port density
• RJ-45 style LC™ connector system
• Half the size of SC Duplex 1x9 transceiver
• Single power supply (3.3 V)
• Extremely low power consumption, 600 mW typical
• Leading performance for receiver sensitivity,
34 dBm typical
• Loss of optical signal indicator
• Laser disable, LVTTL input
• LVPECL differential inputs and outputs
• Suitable for multirate applications up to 155 Mbit/s
Fast Ethernet (FE) compatible
• Class 1 FDA and IEC laser safety compliant
• UL 94 V-0 certified
• Compliant with FCC (Class B) and EN 55022
• Distance up to 15 km/21 km on single mode fiber (SMF)2)Specifications
| Parameter |
Symbol |
Limit Values |
Unit |
|
min. |
max. |
| Package Power Dissipation |
|
|
0.9 |
W |
| Supply Voltage |
VCCVEE |
|
4 |
V |
| Data Input Levels |
|
VCC+0.5 |
VCC0.5 |
V |
| Differential Data Input Voltage Swing |
VIDpk-pk |
|
5 |
V |
| Storage Ambient Temperature |
|
40 |
85 |
|
| Hand Lead Soldering Temp/Time |
|
|
260/10 |
/S |
| Wave Soldering Temp/Time |
|
|
260/10 |
/S |
| Aqueous Wash Pressure |
|
|
< 110 |
psi |
Exceeding any one of these values may destroy the device immediately.
DescriptionThis data sheet describes the Infineon single mode ATM transceiver, which complies with the ATM Forum's Network Compatible ATM for Local Network Applications document and ANSI's Broadband ISDN - Customer Installation Interfaces, Physical Media Dependent Specification, T1E1.2, compliant to SONET OC-3, IR-1 (Telcordia GR-253-CORE) and SDH STM-1/S-1.1 (ITU-T G.957).
This ATM transceiver is also suitable for multirate applications. The performance at lower datarates may vary from application to application and is link dependent. Refer to Infineon Application Note 97 for more information.
ATM was developed to facilitate solutions in multimedia applications and real time transmission. The data rate is scalable, and the ATM protocol is the basis of the broadband public networks being standardized in the International Telecommunications Union (ITU), the former International Telegraph and Telephone Consultative Committee (CCITT). ATM can also be used in local private applications.
ATM was developed to facilitate solutions in multimedia applications and real time transmission. The data rate is scalable, and the ATM protocol is the basis of the broadband public networks being standardized in the International Telecommunications Union (ITU), the former International Telegraph and Telephone Consultative Committee (CCITT). ATM can also be used in local private applications.
The Infineon single mode ATM transceiver is a single unit comprised of a transmitter, a receiver, and an LC receptacle. This design frees the customer from many alignment and PC board layout concerns. The module is designed for low cost LAN and WAN applications. ATM can be used as the network end device interface in workstations, servers, and storage devices, and in a broad range of network devices such as bridges, routers, and intelligent hubs, as well as local and wide area ATM switches.
This ATM transceiver operates at up to 155.520 Mbit/s from a single power supply (+3.3 V). The full differential data inputs and outputs are LVPECL compatible.
V23818-C18-Lxx/L4xx Data Sheet
