Infrared Receivers 2.7-5.5V 40kHz 45Deg
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Features: · Photo detector and preamplifier in one package· Internal filter for PCM frequency· Imp...
Features: Photo detector and preamplifier in one packageInternal filter for PCM frequencyImproved ...
Carrier Frequency : | 40 KHz | Transmission Distance : | 45 m | ||
Viewing Angle : | 45 deg | Output Current : | 5 mA | ||
Operating Voltage : | 2.7 V to 5.5 V | Supply Current : | 0.85 mA | ||
Power Dissipation : | 10 mW | Maximum Operating Temperature : | + 85 C | ||
Minimum Operating Temperature : | - 25 C | Packaging : | Tube |
The TSOP2240 series are miniaturized receivers for infrared remote control systems. PIN diode and preamplifier are assembled on lead frame, the epoxy package is designed as IR filter. The features of it are as follows:(1)photo detector and preamplifier in one package; (2)internal filter for PCM frequency; (3)TTL and CMOS compatibility; (4)output active low; (5)improved shielding against electrical field disturbance; (6)suitable burst length10 cycles/burst.
What comes next is about the TSOP2240 maximum ratings: (1)supply voltage: -0.3V to 6.0V; (2)supply current: 5mA; (3)output voltage: -0.3V to 6.0V; (4)output current: 5mA; (5)junction temperature: 100; (6)storage temperature range: -25 to +85; (7)operating temperature range: -25 to +85; (8)power consumption: 50 mW; (9)soldering temperature: 260.
The following is about the TSOP2240 electrical characteristics:(1)supply current (Pin 3): 1.1mA typical,0.8mA min and 1.5 mA max at VS = 5V, Ev = 0 and 1.4mA typical at VS = 5V, Ev = 40 klx, sunlight; (2)supply voltage: 4.5V min and 5.5V max; (3)transmission distance: 35m typical at Ev = 0, test signal see fig.7, IR diode TSAL6200, IF = 300mA; (4)output voltage low (Pin 3): 250mV max at IOSL = 0.5 mA,Ee = 0.7 mW/m2,f = fo; (5)irradiance (30 - 40 kHz):0.2 mW/m2 typical and 0.4 mW/m2 max at pulse width tolerance: tpi 5/fo < tpo < tpi + 6/fo, test signal(see fig.7); (6)irradiance (56 kHz):0.3 mW/m2 typical and 0.5 mW/m2 max at Pulse width tolerance: tpi 5/fo < tpo < tpi + 6/fo, test signal see fig.7; (7)irradiance: 30 W/m2 min at tpi 5/fo < tpo < tpi + 6/fo; (8)directivity: ±45 deg typical at angle of half transmission distance.