Features: Dropout voltage typically 0.5V @Io=500mA Output current up to 500mA Logic control electronic shutdown Output voltage trimmed before assembly -18V Reverse peak voltage +30V Input over voltage protection +60V Transient ...
TS2938: Features: Dropout voltage typically 0.5V @Io=500mA Output current up to 500mA Logic control electronic shutdown Output voltage trimmed before assembly⣷...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Features: ·Output voltage compatible with DTL, ECL, TTL, ·MOS and CMOS Logic Levels ·Low input bia...
Dropout voltage typically 0.5V @Io=500mA
Output current up to 500mA
Logic control electronic shutdown
Output voltage trimmed before assembly
-18V Reverse peak voltage
+30V Input over voltage protection
+60V Transient peak voltage
Low quiescent current 100uA typ. (ON mode),
Internal current limit
Thermal shutdown protection
The TS2938/A series is a high performance with low dropout voltage regulator suitable for moderate to high current and voltage regulator application. Its 500Mv (typ) dropout voltage at full load and over temperature makes it especially valuable in battery power systems and as high efficiency noise filters in post regulator applications. Unlike normal NPN transistor design, where the base to emitter voltage drop and collector to emitter saturation voltage limit the minimum dropout voltage, dropout performance of the PNP output of these devices is limited only by low Vce saturation voltage.
The TS2938/A series is fully protected from damage due to fault conditions. Linear current limiting is provided. Output current during overload conditions is constant. Thermal shutdown the device when the die temperature exceeds the maximum safe operating temperature. Transient protection allows device survival even when the input voltage spikes above and below nominal. The output structure of these regulators allows voltages in excess of the desired output voltage to be applied without reverse current flow.
Input Supply Voltage (Note 2) |
vin |
-18 ~ +60 | V |
Operation Input Supply Voltage | vin(operate) | 26 | V |
Power Dissipation (Note 3) | PD | Internally Limited | W |
Operating Junction Temperature Range | TJ | -40 ~ +125 | |
Storage Temperature Range | TSTG | -65 ~ +150 | |
Lead Soldering Temperature (260 ) TO-252 / SOP-8 Package |
5 | S |
The TS2938/A series of fixed-voltage monolithic micro-power voltage regulators is designed for a wide range of applications. This device excellent choice of use in battery-power application. Furthermore, the quiescent current increases on slightly at dropout, which prolongs battery life.
This series of fixed-voltage regulators features very low ground current (100uA Typ.), very low drop output voltage (Typ. 60mV at light load and 600mV at 500mA) and output inhibit control. This includes a tight initial tolerance of 1% (TS2938A) and 2% (TS2938), extremely good line regulation of 0.05% typ., and very low output temperature coefficient. This series is offered in 5-pin of TO-252-5L and 8-pin SOP-8 package.