Features: ` Single-Chip and Single-Supply Interface for IBM™ PC/AT™ Serial Port` ESD Protection for RS-232 Bus Pins ±15-kV Human-Body Model (HBM) ±8-kV IEC61000-4-2, Contact Discharge ±15-kV IEC61000-4-2, Air-Gap Discharge` Meets or Exceeds Requirements of TIA/EIA-232-F and ITU v.28...
TRS3243E: Features: ` Single-Chip and Single-Supply Interface for IBM™ PC/AT™ Serial Port` ESD Protection for RS-232 Bus Pins ±15-kV Human-Body Model (HBM) ±8-kV IEC61000-4-2, Contact Discharge ...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
US $.74 - 1.18 / Piece
RS-232 Interface IC 3V-5.5V Sgl-Channel RS232 Line Drvr/Rcvr
US $.74 - 1.18 / Piece
RS-232 Interface IC 3V-5.5V Sgl-Channel RS232 Line Drvr/Rcvr
US $.41 - .46 / Piece
RS-232 Interface IC 3V-5.5V Sgl-Channel RS232 Line Drvr/Rcvr
MIN | MAX | UNIT | ||
VCC Supply voltage range(2) | -0.3 | 6 | V | |
V+ Positive output supply voltage range(2) | -0.3 | 7 | V | |
V Negative output supply voltage range(2) | 0.3 | -77 | V | |
V+ V Output supply voltage difference(2) | 13 | V | ||
VI Input voltage range | Driver (FORCEOFF, FORCEON) | -0.3 | 6 | V |
Receiver | -25 | 25 | ||
VO Output voltage range | Driver | -13.2 | 13.2 | V |
Receiver (INVALID) | -0.3 | VCC + 0.3 | ||
JA Package thermal impedance(3) (4) | DB package | 62 | /W | |
DW package | 46 | |||
PW package | 62 | |||
Lead temperature 1,6 mm (1/16 in) from case for 10 s | 260 | |||
Tstg Storage temperature range | -65 | 150 |
The TRS3243E device consists of three line drivers, five line receivers, and a dual charge-pump circuit with ±15-kV ESD (HBM and IEC61000-4-2, Air-Gap Discharge) and ±8-kV ESD (IEC61000-4-2, Contact Discharge) protection on serial-port connection pins. The TRS3243E meets the requirements of TIA/EIA-232-F and provides the electrical interface between an asynchronous communication controller and the serial-port connector. This combination of drivers and receivers matches that needed for the typical serial port used in an IBM PC/AT, or compatible. The charge pump and four small external capacitors of TRS3243E allow operation from a single 3-V to 5.5-V supply. In addition, the device includes an always-active noninverting output (ROUT2B), which allows applications using the ring indicator to transmit data while the device is powered down. The TRS3243E operates at data signaling rates up to 250 kbit/s and a maximum of 30-V/ms driver output slew rate.
Flexible control options for power management are available when the serial port is inactive. The auto-powerdown feature functions when FORCEON is low and FORCEOFF is high. During this mode of operation, if the TRS3243E does not sense a valid RS-232 signal, the driver outputs are disabled. If FORCEOFF is set low, both drivers and receivers (except ROUT2B) are shut off, and the supply current is reduced to 1 mA. Disconnecting the serial port or turning off the peripheral drivers causes the auto-powerdown condition to occur.
Auto-powerdown of TRS3243E can be disabled when FORCEON and FORCEOFF are high, and should be done when driving a serial mouse. With auto-powerdown enabled, the device is activated automatically when a valid signal is applied to any receiver input. The INVALID output is used to notify the user if an RS-232 signal is present at any receiver input. INVALID is high (valid data) if any receiver input voltage of TRS3243E is greater than 2.7 V or less than 2.7 V or has been between 0.3 V and 0.3 V for less than 30 ms. INVALID is low (invalid data) if all receiver input voltages are between 0.3 V and 0.3 V for more than 30 ms. Refer to Figure 5 for receiver input levels.
The TRS3243EC is characterized for operation from 0 to 70. The TRS3243EI is characterized for operation from 40 to 85.