Features: Controlled Baseline One Assembly/Test Site, One Fabrication SiteEnhanced Diminishing Manufacturing Sources (DMS) SupportEnhanced Product Change NotificationQualification Pedigree†1.5-A Low-Dropout Voltage RegulatorAvailable in 1.5-V, 1.8-V, 2.5-V, 3.3-V, Fixed Output and Adjustable...
TPS75318-EP: Features: Controlled Baseline One Assembly/Test Site, One Fabrication SiteEnhanced Diminishing Manufacturing Sources (DMS) SupportEnhanced Product Change NotificationQualification Pedigree†1.5...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Controlled Baseline One Assembly/Test Site, One Fabrication Site
Enhanced Diminishing Manufacturing Sources (DMS) Support
Enhanced Product Change Notification
Qualification Pedigree†
1.5-A Low-Dropout Voltage Regulator
Available in 1.5-V, 1.8-V, 2.5-V, 3.3-V, Fixed Output and Adjustable Versions
Open Drain Power-Good (PG) Status Output (TPS751xxQ)
Open Drain Power-On Reset With 100-ms Delay (TPS753xxQ)
Dropout Voltage Typically 160 mV at 1.5 A (TPS75133Q)
Ultralow 75 A Typical Quiescent Current
Fast Transient Response
2% Tolerance Over Specified Conditions For Fixed-Output Versions
20-Pin TSSOP (PWP) PowerPADTM Package
Thermal Shutdown Protection
Input voltage range‡, VI . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .0.3 V to 5.5 V
Voltage range at EN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.3 V to 16.5 V
Maximum PG voltage (TPS751xxQ) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16.5 V
Maximum RESET voltage (TPS753xxQ) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16.5 V
Peak output current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Internally limited
Continuous total power dissipation . . . . . . . . . . . . . . . . . . . . . . . . . See dissipation rating tables
Output voltage, VO (OUTPUT, FB) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5.5 V
Operating virtual junction temperature range, TJ . . . . . . . . . . . . . . . . . . . . . . 40°C to 125°C
Storage temperature range, Tstg . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .65°C to 150°C
ESD rating, HBM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 kV
The TPS75318-EP are low dropout regulators with integrated power-on reset and power-good (PG)functions respectively. These devices are capable of supplying 1.5 A of output current with a dropout of 160 mV(TPS75133Q, TPS75333Q). Quiescent current is 75 A at full load and drops down to 1 A when the device is disabled. TPS75318-EP are designed to have fast transient response for larger load current changes.
Because the PMOS device TPS75318-EP behaves as a low-value resistor, the dropout voltage is very low (typically 160 mV at an output current of 1.5 A for the TPS75x33Q) and is directly proportional to the output current. Additionally, since the PMOS pass element is a voltage-driven device, the quiescent current is very low and independent of output loading (typically 75 A over the full range of output current, 1 mA to 1.5 A). These two key specifications of TPS75318-EP yield a significant improvement in operating life for battery-powered systems.
The TPS75318-EP is enabled when EN is connected to a low level voltage. This LDO family also features a sleep mode;applying a TTL high signal to EN (enable) shuts down the regulator, reducing the quiescent current to less than 1A at TJ = 25°C.
For the TPS751xxQ, the power-good terminal (PG) is an active high, open drain output, which can be used to implement a power-on reset or a low-battery indicator.
The RESET (SVS, POR, or power on reset) output of the TPS75318-EP initiates a reset in microcomputer and microprocessor systems in the event of an undervoltage condition. An internal comparator in the TPS753xxQ monitors the output voltage of the regulator to detect an undervoltage condition on the regulated output voltage.When the output reaches 95% of its regulated voltage, RESET goes to a high-impedance state after a 100-ms delay.RESET of TPS75318-EP goes to a logic-low state when the regulated output voltage is pulled below 95% (i.e., over load condition) of its regulated voltage.
The TPS75318-EP is offered in 1.5-V, 1.8-V, 2.5-V and 3.3-V fixed-voltage versions and in an adjustable version (programmable over the range of 1.5 V to 5 V). Output voltage tolerance is specified as a maximum of 2% over line, load, and temperature ranges. The TPS75318-EP are available in 20-pin TSSOP (PWP) packages.