TPS71530-Q1

` Qualification in Accordance With AEC-Q100 (1)
` Qualified for Automotive Applications
` Customer-Specific Configuration Control Can Be Supported Along With Major-Change Approval
` 24-V Maximum Input Voltage
` Low 3.2-mA Quiescent Current at 50 mA
` Stable With Any Capacitor (>0.47 mF)
` 50-mA Low-Dropout Regulator
` Available in 2.5 V, 3 V, 3.3 V, 5 V, and Adjustable (1.2 V to 15 V)
` Minimum/Maximum Specified Current Limit
` 5-Pin SC70/SOT-323 (DCK) Package
` 40 to 125 Specified Junction Temperature Range

V_IN range .......................0.3 V to 24 V
V_OUT range..................... 0.3 V to 16.5 V
Peak output current ................ Internally limited
ESD rating, HBM .........................2 kV
ESD rating, CDM ........................500 V
Continuous total power dissipation ..See Dissipation Rating Table
Junction temperature range, T_J ...........40 to 150
Storage temperature range, T_stg ..........65 to 150

(1) Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated under recommended operating conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device  eliability.
(2) All voltage values are with respect to network ground terminal.

The TPS715xx low-dropout (LDO) voltage regulators offer the benefits of high input voltage, LDO voltage, low-power operation, and miniaturized packaging. The TPS715xx, which operate over an input range of 2.5 V to 24 V, are stable with any capacitor (>0.47 F). The LDO voltage and low quiescent current allow operations at extremely low power levels. Therefore, the TPS715xx are ideal for powering battery-management ICs. Specifically, since the devices are enabled as soon as the applied voltage reaches the minimum input voltage, the output is quickly available to power continuously operating battery-charging ICs.

The usual PNP TPS715xx pass transistor has been replaced by a PMOS pass element. Because the PMOS pass element behaves as a low-value resistor, the LDO voltage, typically 415 mV at 50 mA of load current, is directly proportional to the load current. The low quiescent current (3.2 A typ)TPS715xx is stable over the entire range of output load current (0 mA to 50 mA).