Features: · 2.7-V to 5.8-V Input Voltage Range· 1.6-MHz Fixed Switching Frequency· 3 Independent Adjustable Outputs· Main Output up to 15 V With <1%Typical Output Voltage Accuracy· Negative Output Voltage Down to -12 V/20 mA· Positive Output Voltage up to 30 V/20 mA· Auxiliary 3.3-V Linear Regu...
TPS65140: Features: · 2.7-V to 5.8-V Input Voltage Range· 1.6-MHz Fixed Switching Frequency· 3 Independent Adjustable Outputs· Main Output up to 15 V With <1%Typical Output Voltage Accuracy· Negative Outpu...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
US $33.48 - 33.48 / Piece
Power Management IC Development Tools 2 batt cells
UNIT | |
Voltages on pin VIN(2) |
-0.3 V to 6.0 V |
Voltages on pin Vo1, SUP, PG (2) |
-0.3 V to 15.5 V |
Voltages on pin EN, MODE, ENR(2) |
-0.3 V to VI + 0.3 V |
Voltage on pin SW(2) |
20 V |
Power good maximum sink current (PG) |
1 mA |
Continuous power dissipation |
See Dissipation Rating Table |
Operating junction temperature range |
-40 to 150 |
Storage temperature range |
-65 to 150 |
Lead temperature (soldering, 10 sec) |
260 |
The TPS65140/145 offers a compact and small power supply solution to provide all three voltages required by thin film transistor (TFT) LCD displays.The auxiliary linear regulator controller can be used to generate a 3.3-V logic power rail for systems powered by a 5-V supply rail only
The main output Vo1 of TPS65140 is a 1.6-MHz fixed frequency PWM boost converter providing the source drive voltage for the LCD display. The device is available in two versions with different internal switch curren limits to allow the use of a smaller external inductor when lower output power is required. The TPS65140 has a typical switch current limit of 2.3 A and the TPS65145 has a typical switch current limit of 1.37 A. A fully integrated adjustable charge pump doubler/tripler provides the positive LCD gate drive voltage. An externally adjustable negative charge pump provides the negative gate drive voltage. Due to the high 1.6-MHz switching frequency of the charge pumps, inexpensive and small 220-nF capacitors of TPS65140 can be used.
Additionally, the TPS65140/145 has a system power good output to indicate when all supply rails are acceptable. For LCD panels powered by 5 V, only the TPS65140/145 has a linear regulator controller using an external transistor to provide a regulated 3.3 V output for the digital circuits. For maximum safety, the entire device goes into shutdown as soon as one of the outputs is out of regulation. The device can be enabled again by toggling the input or the enable (EN) pin to GND.