TPS61092

The TPS6109x devices provide a power supply solution for products powered by either a one-cell Li-Ion or Li-polymer, or a two-cell alkaline, NiCd or NiMH battery and required supply currents up to or higher than 1 A. The TPS6109x generates a stable output voltage that is either adjusted by an external resistor divider or fixed internally on the chip. It provides high efficient power conversion and is capable of deliveing output currents up to 0.5Aat 5V at a supply voltage down to 1.8V .The implemented boost converter of TPS6109x is based on a fixed frequency, pulse-width- modulation (PWM) controller using a synchronous rectifier to obtain maximum efficiency. Boost switch and rectifier switch are connected internally to provide the lowest leakage inductance and best EMI behavior possible. The maximum peak current of TPS6109x in the boost switch is limited to a value of 2500 mA.

The TPS6109x can be disabled to minimize battery drain. During shutdown, the load is completely disconnected from the battery. A low-EMI mode is implemented to reduce ringing and, in effect, lower radiated electromagnetic energy when the converter enters the discontinuous conduction mode.

The output voltage of TPS6109x can be programmed by an external resistor divider or is fixed internally on the chip.

The TPS6109x is packaged in a 16-pin QFN 4 x 4 mm (16 RSA) package