TPS5300

·Power Stage Input Voltage Range of 3 V to 28V
·Single-Chip Dynamic Output Voltage Transition Solution
·Hysteretic Controller Provides Fast Transient Response Time and Reduced Output Capacitance
·Two Linear Regulator Controllers Regulating Clock and I/O Voltages
·Internal 2-A (Typ) Gate Drivers With Bootstrap Diode For Increased Efficiency
·5-Bit Dynamic VID
·Active Droop Compensation Enables Tight Dynamic Regulation for Reduced Output Capacitance
·VGATE Terminal Provides Power-Good Signal for All Three Outputs
·Enable External Terminal (ENABLE_EXT)
·32-Pin TSSOP PowerPAD^TMEnhances Thermal Performance
·1% Reference Voltage Accuracy

The TPS5300 is a hysteretic synchronous-buck controller, with two on-chip linear regulator controllers, incorporating mic output voltage positioningtechnology. The TPS5300 provides a precise, programmable supply voltage to a mobile essor orother processor power applications. A ripple regulator provides the core voltage, while two linear regulator drivers te external NPN power transistors for the I/O and CLK voltages. A 5-bit voltage identification (VID) DAC llows programming for the ripple regulator voltage to values between 0.925 V to 1.275V in 25-mV, steps and 1.3 V to 2 V in 50-mV steps. r voltage ranges and steps can be easily set. The fast transient response time and active voltage DROOP TPS5300 positioning uce the number of output capacitors required to keep the output voltage within tight dynamic voltage regulation limits. The power saving mode (PSM) allows the user to select a single operating ramp or allows the controller to automatically tch to lower frequencies at low loads. The high-gain current sense differential amplifier allows the use of small-value sense resistors that minimize conduction losses.

The TPS5300 includes high-side and low-side gate drivers rated at 2 A typical, that enable efficient operation at higher frequencies and drive larger or multiple power MOSFETs (such as 50-A output current applications).An adaptive dead-time circuit minimizes dead-time losses while preventing cross-conduction of high-side and low-side switches. All three outputs power up together as they track the same user programmable slowstart voltage. The enable external (ENABLE_EXT) terminal allows the TPS5300 to activate external switching controllers for additional system power requirements.

The TPS5300 features V_CC  undervoltage lockout, output overvoltage protection, output undervoltage protection, and user-programmable overcurrent protection, and is packaged in a small 32-pin TSSOP PowerPAD package.