DC/DC Switching Controllers Dual Sync Step Down for Lo-Vltg Sys Pwr
TPS51124RGET: DC/DC Switching Controllers Dual Sync Step Down for Lo-Vltg Sys Pwr
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
US $1.45 - 2.33 / Piece
DC/DC Switching Controllers Lo Inpt Vltg Triple Ch Cntrllr
US $.97 - 1.05 / Piece
DC/DC Switching Controllers Lo Input Vltg Triple Ch Cntrlr
Input Voltage : | 3 V to 28 V | Output Voltage : | 0.75 V to 5.5 V |
Output Current : | 15 A | Number of Outputs : | 2 |
Maximum Operating Temperature : | + 85 C | Mounting Style : | SMD/SMT |
Package / Case : | QFN-24 |
The TPS51124RGET belongs to the TPS51124 family, which is a dual, adaptive on-time D-CAP™ mode synchronous buck controller. The part enables system designers to cost effectively complete the suite of notebook power bus regulators with the absolute lowest external component count and lowest standby consumption. The fixed frequency emulated adaptive on-time control of TPS51124RGET supports seamless operation between PWM mode at heavy load condition and reduced frequency operation at light load for high efficiency down to milliampere range. The main control loop for the TPS51124 uses the D-CAP mode that optimized for low ESR output capacitors such as POSCAP or SP-CAP promises fast transient response with no external compensation. Simple and separate power good signals for each channel allow flexibility of power sequencing.
The features of TPS51124RGET are (1) high efficiency; low-power consumption; shutdowns to <1 µA; (2) fixed frequency emulated on-time control; frequency selectable from three options; (3) auto-skip mode; (4) D-CAP™ mode enables fast transient response; (5) low output ripple; (6) less than 1% initial reference accuracy; (7) output voltage range: 0.76 v to 5.5 v; (9) wide input voltage range: 3 v to 28 v; (10) low-side RDS(ON) loss-less current sensing; (11) adaptive gate drivers with integrated boost diode; (12) power-good signals for each channel with delay timer; (13) internal 1.2-ms voltage-servo soft start; (14) output discharge during disable; fault; which can be used in notebook i/o and low voltage system bus.
The absolute maximum ratings of TPS51124RGET (note1: Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress rating only and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability. ) of TPS51125RGET (over operating free-air temperature range (unless othenrvise noted)) are Input voltage range(note1)(1)(VBST1, VBST2 -0.3 to 36V, VBST1, VBST2(wrt LLx): -0.3 to 6V; (2)V5IN, V5FILT, EN1, EN2, VFB1, VFB2, VO1, VO2, TONSEL, TRIP1: -0.3 to 6V; (3)output voltage range DRVH1, DRVH2: -1.0 to 36V; (4)DRVH1, DRVH2(wrt LLx): -0.3 to 6V; (5)LL1,LL2: -2 to 30V, PGOOD1, PGOOD2, DRVL1, DRVL2: -0.3 to 6V; (6)PGND1, PGND2: -0.3 to 0.3 V; Junction temperature range: -40 to 125 ,;Tstg(storage temperature): -55 to 150; TA(operating amibient temperature range): -40 to 85.
Technical/Catalog Information | TPS51124RGET |
Vendor | Texas Instruments (VA) |
Category | Integrated Circuits (ICs) |
Type | Step-Down (Buck) |
Number of Outputs | 2 |
Voltage - Input | 3 ~ 28 V |
Voltage - Output | 0.76 ~ 5.5 V |
Current - Output | 15A |
Power - Output | 2.33W |
Package / Case | 24-VQFN |
Packaging | Cut Tape (CT) |
Internal Switch(s) | No |
Synchronous | Yes |
Rds (On) | - |
Operating Temperature | -40°C ~ 85°C |
Frequency - Switching | Up to 420kHz |
Drawing Number | 296; 4204104-2; RGE; 24 |
Lead Free Status | Lead Free |
RoHS Status | RoHS Compliant |
Other Names | TPS51124RGET TPS51124RGET 296 19295 1 ND 296192951ND 296-19295-1 |