Features: Replaces OR-ing Diodes Operating Supply Range of −12 V to −80 V Withstands Transients to 100 V Programmable Current Limit Programmable Linear Inrush Slew Rate Programmable UV/OV Thresholds Programmable UV and OV Hysteresis Fault Timer to Eliminate Nuisance Trips Power Good an...
TPS2350: Features: Replaces OR-ing Diodes Operating Supply Range of −12 V to −80 V Withstands Transients to 100 V Programmable Current Limit Programmable Linear Inrush Slew Rate Programmable UV/O...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
US $.42 - .86 / Piece
Power Switch ICs - USB Sgl Channel,Crnt-Ltd USB Pwr Dist Switch
US $.28 - .3 / Piece
Power Switch ICs - USB Sgl Channel,Crnt-Ltd USB Pwr Dist Switch
US $.53 - .86 / Piece
Power Switch ICs - USB SGL CH,CURRENT-LTD USB PWR DISTR SWITCH
PARAMETER | TPS2350 | UNIT |
Input voltage range, RTN (2) | −0.3 to 100 | V |
Input voltage range, −VINA to VINB | −100 to 100 | |
Input voltage range, FLTTIM, RAMP, SENSE, OV, UV (2) | −0.3 to 15 | |
Output voltage range, FLT, PG (2)(3) | −0.3 to 100 | |
Continuous output current,FLT, PG | 10 | mA |
Continuous total power dissipation | TBD | °C |
Operating junction temperature range, TJ | −55 to 125 | |
Storage temperature range, Tstg | −65 to 150 | |
Lead temperature soldering 1,6 mm (1/16 inch) from case for 10 seconds | 260 |
The TPS2350 is a hot swap power manager optimized for replacing OR-ing diodes in redundant power −48-V systems. The TPS2350 operates with supply voltages from −12 V to −80 V, and withstands spikes to −100 V.
The TPS2350 uses two power FETs as low voltage drop diodes to efficiently select between two redundant power supplies. This minimizes system power dissipation and also minimizes voltage drop through the power management chain.
The TPS2350 also uses a third power FET to provide load current slew rate control and peak current limiting that is programmed by one resistor and one capacitor. The device also provides a power good output to enable down-stream power converters and a fault output to indicate load problems.