TLV2334

Supply voltage, V_DD (see Note 1)  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  . . . .  . 8 V
Differential input voltage, VID (see Note 2)  . . . . . . . . . . . . . . . . . . . . . .  . . . . . . V_DD±
Input voltage range, VI (any input)  . . . . . . . . . . . . . . . . . . . . . . . . . .  . .0.3 V to V_DD
Input current, I_I  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .   . .±5 mA
Output current, I_O . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . ±30 mA
Duration of short-circuit current at (or below) TA = 25 (see Note 3)  . .   . . . unlimited
Continuous total dissipation  . . . . . . . . . . . . . . . . . . . . .. . .See Dissipation Rating Table
Operating free-air temperature range, T_A  . . . . . . . . . . . . . . . . . . . . .. . . .40 to 85
Storage temperature range  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ... 65 to 150
Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds  . . . . . . . . .  . . . . 260
† Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTES: 1. All voltage values, except differential voltages, are with respect to network ground.
2. Differential voltages are at the noninverting input with respect to the inverting input.
3. The output may be shorted to either supply. Temperature and /or supply voltages must be limited to ensure that the maximum dissipation rating is not exceeded (see application section).

The TLV233x operational amplifiers are in a family of devices that has been specifically designed for use in low-voltage single-supply applications. Unlike the TLV2322 which is optimized for ultra-low power, the TLV233x is designed to provide a combination of low power and good ac performance. Each amplifier is fully functional down to a minimum supply voltage of 2 V, is fully characterized, tested, and specified at both 3-V and 5-V power supplies. The common-mode input-voltage range includes the negative rail and extends to within 1 V of the positive rail.

Having a maximum supply current of only 310 mA per amplifier over full temperature range, the TLV233x devices offer a combination of good ac performance and microampere supply currents. From a 3-V power supply, the amplifier's typical slew rate is 0.38 V/ms and its bandwidth is 300 kHz.