TLRE16T

The TLRE16T is a panel circuit indicator.If the lead is formed, the lead should be formed up to 5 mm from the body of the device without forming stress to the resin. Soldering should be performed after lead forming.This visible LED lamp also emits some IR light.If a photodetector is located near the LED lamp, please ensure that it will not be affected by this IR light.

The TLRE16T has the following features including:(1)5 mm package; (2)all plastic mold type; (3)transparent lens; (4)high intensity light emission; (5)excellent low current light output; (6)applications: outdoor message signboards, safety equipment.Toshiba is continually working to improve the quality and the reliability of their products.Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and their vulnerability to physical stress. It is the responsibility of the buyer, when utilizing Toshiba products, to observe standards of safety, and to avoid situations in which the malfunction or failure of a Toshiba product could cause loss of human life, bodily injury or damage to property.

The absolute maximum ratings of the TLRE16T are:(1)storage temperature:-40 to 120; (2)operating temperature:-40 to 100; (3)reverse voltage:4V; (4)forward current:50A;(5)power disspation:120W.The maximum ratings are the limit values which must not be exceeded during operation of device. None of these rating value must not be exceeded. If the maximum rating value is exceeded, the characteristics of devices may never be restored properly. In extreme cases, the device may be permanently damages.Some optical modules come with a protective cap.The protective cap is used to avoid malfunction when the optical module is not in use. Note that it is not dust or waterproof.As mentioned before, optical modules are optical components. Thus, in principle,soldering where there may be flux residue and flux removal after soldering is not recommended.Toshiba recommend that soldering be performed without the optical module mounted on the board.Then, after the board has been cleaned, the optical module should be soldered on to the board manually.