TLRE1008A

Specifications

Opto-Electrical Characteristics (Ta=25°C) Characteristics Symbol Test Condition Min Typ Max Unit Forward Voltage V_F IF=20mA - 1.90
2.40
V Reverse Current I_R VR=4V - - 50
A Luminous Intensity I_V IF=20mA 27
70
- mcd Viewing Angle 2q1/2 - - 110° - deg Peak Wavelength lpeak IF=20mA - 644
- nm Dominant Wavelength lD IF=20mA - 630
- nm Spectral Line Half-Width Dl1/2 IF=20mA - 18
- nm




Description

The TLRE1008A is a panel circuit indicator.TOSHIBA is continually working to improve the quality and the reliability of its products. Nevertheless,semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress.

The TLRE1008A has the following features including:(1)it can be manufactured high-luminosity of equipment or reduce of electric power consumption by change in the high-luminosity LED from general-luminosity one; (2)colors:red, orange, yellow, green, pure green; (3)since the products are only 0.6 mm thick, they are suitable for use in thin equipment; (4)incorporates opaque diffusing resin; (5)good light diffusion-ideal for backlighting; (6)can be mounted using surface mounter; (7)reflow soldering is possible.Toshiba is continually working to improve the quality and the reliability of their products.Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and their vulnerability to physical stress. TLRE1008A is the responsibility of the buyer, when utilizing Toshiba products, to observe standards of safety, and to avoid situations in which the malfunction or failure of a Toshiba product could cause loss of human life, bodily injury or damage to property.

The absolute maximum ratings of the TLRE1008A are:(1)storage temperature:-40 to 100; (2)operating temperature:-40 to 85; (3)reverse voltage:4V; (4)forward current:25A;(5)power disspation:60W.The maximum ratings are the limit values which must not be exceeded during operation of device. None of these rating value must not be exceeded. If the maximum rating value is exceeded, the characteristics of devices may never be restored properly. In extreme cases, the device may be permanently damages.Some optical modules come with a protective cap.The protective cap is used to avoid malfunction when the optical module is not in use. Note that it is not dust or waterproof.As mentioned before, optical modules are optical components. Thus, in principle,soldering where there may be flux residue and flux removal after soldering is not recommended.Toshiba recommend that soldering be performed without the optical module mounted on the board.Then, after the board has been cleaned, the optical module should be soldered on to the board manually.