Features: `4 pin SSOP (SSOP4) : 1.8 mm high, 1.27 mm pitch `Open Voltage : 7V (min) `Short Current : 5A (min) `Isolation Voltage : 1500Vrms (min) ApplicationThe TOSHIBA SSOP coupler TLP3904 is a small outline coupler, suitable for surface mount assembly. The TLP3904 consists of a GaAs light emitti...
TLP3904: Features: `4 pin SSOP (SSOP4) : 1.8 mm high, 1.27 mm pitch `Open Voltage : 7V (min) `Short Current : 5A (min) `Isolation Voltage : 1500Vrms (min) ApplicationThe TOSHIBA SSOP coupler TLP3904 is a sma...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Features: · Peak Off-State Voltage : 400 V (min)· Trigger LED Current : 15 mA (max) (TLP3021(S)) 1...
The TOSHIBA SSOP coupler TLP3904 is a small outline coupler, suitable for surface mount assembly.
The TLP3904 consists of a GaAs light emitting diode, optically coupled to a series connected photo diode array which is suitable for MOS FET gate drive.
CHARACTERISTIC |
SYMBOL |
RATING |
UNIT | ||
LED | Forward Current |
IF |
50 |
mA | |
Forward Current Derating (Ta25) |
IF/ |
-0.5 |
mA/ | ||
Reverse Voltage |
VR |
5 |
V | ||
Junction Temperature |
Tj |
125 |
|||
DETECTOR | Forward Current |
IFD |
50 |
V | |
Reverse Voltage |
VRD |
10 |
A | ||
Junction Temperature |
Tj |
125 |
|||
Storage Temperature Range |
Tstg |
-55~125 |
|||
Operating Temperature Range |
Topr |
-40~85 |
|||
Lead Soldering Temperature (10 s) |
Tsol |
260 |
|||
Isolation Voltage (AC, 1 minute, R.H.60%) (NOTE1) |
BVS |
1500 |
Vrms |
Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook ("Handling Precautions"/"Derating Concept and Methods") and individual reliability data (i.e. reliability test report and estimated failure rate, etc).
Note 1: Device considered a two terminal device: Pins 1 and 2 shorted together and pins 3 and 4 shorted together.