DescriptionThe TLGE1002 is a panel circuit indicator.The LED devices is packed in an aluminum envelope with silica gel to avoid moisture absorption.The optical characteristics may be affected by exposure to moisture in the air before soldering and it should be stored under the following condition.
The TLGE1002 has the following features including:(1)it can be manufactured high-luminosity of equipment or reduce of electric power consumption by change in the high-luminosity LED from general-luminosity one; (2)colors:red, orange, yellow, green, pure green; (3)can be mounted using surface mounter; (4)reflow soldering is possible;(5)standard embossed taping 4 mm pitch:T02 (3000 pcs/reel);(6)applications:as backlighting source for battery-powered equipment as pilot light for compact equipment in low-power electronic equipment, etc.Tape material protected against static electricity. However, static electricity may occur depending on quantity of charged static electricity and a device may attach to a tape, or a device may be unstable when peeling a tape cover.
The absolute maximum ratings of the TLGE1002 are:(1)storage temperature:-40 to 100; (2)operating temperature:-40 to 85; (3)reverse voltage:4V; (4)forward current:25mA;(5)power disspation:60mW.The maximum ratings are the limit values which must not be exceeded during operation of device. None of these rating value must not be exceeded. If the maximum rating value is exceeded, the characteristics of devices may never be restored properly. In extreme cases, the device may be permanently damages.Some optical modules come with a protective cap.The protective cap is used to avoid malfunction of the TLGE1002 when the optical module is not in use. Note that it is not dust or waterproof.As mentioned before, optical modules are optical components. Thus, in principle,soldering where there may be flux residue and flux removal after soldering is not recommended.Toshiba recommend that soldering be performed without the optical module mounted on the board.Then, after the board has been cleaned, the optical module should be soldered on to the board manually.
TLGE1002 Data Sheet
