Pinout
SpecificationsSupply voltage, VCC+ (see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22 V
Supply voltage, VCC . . . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . .. . . . . 22 V
Differential input voltage, VID (see Note 2) . . . . . . .. . . . . . . . . . . . . . . ±44 V
Input voltage, VI (any input) . . . . . . . . .. . . . . . . . . . . . . . . . . . . . . . . . . VCC±
Input current, II (each input) . . . . . . .. . . . . . . . . . . . . . . . . . . . . . . . . . ±1 mA
Output current, IO . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . .. . . . . . . . . ±80 mA
Total current into VCC+ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. .. . . . . . 80 mA
Total current out of VCC. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . . 80 mA
Duration of short-circuit current at (or below) 25°C (see Note 3) . . . unlimited
Continuous total power dissipation . . . . . . . .. . . See Dissipation Rating Table
Operating free-air temperature range, TA: TL3307x. . . . . . . . 40°C to 105°C
TL3407x . . . . . . . . . . .0°C to 70°C
TL3507x . . . . . . . .55°C to 125°C
Storage temperature range, Tstg . . . . . . . . . . . . . . . . . . . . . .65°C to 150°C
Lead temperature 1.6 mm (1/16 inch) from case for 10 seconds: D, DW, N, or P package 260°C . . . . . . . . .
† Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTES: 1. All voltage values, except differential voltages, are with respect to the midpoint between VCC+ and VCC.
2. Differential voltages are at the noninverting input with respect to the inverting input. Excessive current flows if input is brought below VCC0.3 V.
3. The output can be shorted to either supply. Temperature and/or supply voltages must be limited to ensure that the maximum dissipation rating is not exceeded.DescriptionQuality, low cost, bipolar fabrication with innovative design concepts are employed for the TL33071/2/4, TL34071/2/4, and TL35071/2/4 series of monolithic operational amplifiers. This series of operational amplifiers offers 4.5 MHz of gain bandwidth product, 13 V/µs slew rate, and fast settling time without the use of JFET device technology. Although this TL33071/2/4, TL34071/2/4, and TL35071/2/4 series series can be operated from split supplies, it is particularly suited for single-supply operation since the common-mode input voltage range includes ground potential (VCC). With a Darlington transistor input stage, this series exhibits high input resistance, low input offset voltage, and high gain. The all-npn output stage, characterized by no dead-band crossover distortion and large output voltage swing, provides high-capacitance drive capability, excellent phase and gain margins, low open-loop high-frequency output impedance, and symmetrical source/sink ac frequency response.
The TL33071/2/4, TL34071/2/4, and TL35071/2/4 series devices are avaliable in standard or prime performance (A-suffix) grades and are specified over the commercial (0°C to 70°C) temperature range. The TL33071/2/4 devices are available in standard or prime performance (A-suffix) grades and are specified over industrial/vehicular (40°C to 105°C) temperature range. The TL33071/2/4, TL34071/2/4, and TL35071/2/4 series devices are avaliable in standard or prime performance (A-suffix) grades and are specified over the military (55°C to 125°C) temperature range. These low-cost amplifiers are available in single, dual, and quad configurations and are pin compatible with the MC33071/2/4, MC34071/2/4, and MC35071/2/4 series of amplifiers. Packaging options include standard plastic DIP and SO packages.
TL3x072A Data Sheet
