TISP4395J3BJ

On-State Voltage :
Non Repetitive On-State Current : 50 A
Maximum Operating Temperature : + 85 C
Mounting Style : SMD/SMT
Package / Case : DO-214AA-2
Breakover Current IBO Max : +/- 600 mA
Off-State Leakage Current @ VDRM IDRM : +/- 5 uA
Holding Current (Ih Max) : +/- 600 mA
Breakover Voltage VBO : +/- 395 V
Off-State Capacitance CO : 35 pF to 105 pF
Rated Repetitive Off-State Voltage VDRM : +/- 320 V


Specifications

Rating	Symbol	Value	Unit
Repetitive peak off-state voltage '4290 '4350 '4395	VDRM	±220 ±275 ±320	V
Non-repetitive peak on-state pulse current (see Notes 1 and 2) 2/10 (Telcordia GR-1089-CORE, 2/10 voltage wave shape) 8/20 (IEC 61000-4-5, combination wave generator, 1.2/50 voltage wave shape) 10/160 (TIA-968-A (Replaces FCC Part 68), 10/160 voltage wave shape) 4/250 (ITU-T K.20/21, 10/700 voltage wave shape, simultaneous) 5/310 (ITU-T K.20/21, 10/700 voltage wave shape, single) 5/320 (TIA-968-A (Replaces FCC Part 68), 9/720 voltage wave shape, single) 10/560 (TIA-968-A (Replaces FCC Part 68), 10/560 voltage wave shape) 10/1000 (Telcordia GR-1089-CORE, 10/1000 voltage wave shape)	IPPSM	1000 800 400 370 350 350 250 200	A
Non-repetitive peak on-state current (see Notes 1 and 2) 50 Hz, 1 cycle 60 Hz, 1 cycle	ITSM	80 100	A
Initial rate of rise of on-state current, Linear current ramp, Maximum ramp value < 50 A	diT/dt	800	A/s
Junction temperature	TJ	-40 to +150	°C
Storage temperature range	Tstg	-65 to +150	°C

NOTES: 1. Initially, the device must be in thermal equilibrium with T_J = 25 °C.
2. These non-repetitive rated currents are peak values of either polarity. The surge may be repeated after the device returns to its initial conditions.


Description

The range of TISP4xxxJ3BJ devices are designed to limit overvoltages on telecom lines. The TISP4xxxJ3BJ is primarily designed to address GR-1089-CORE compliance on data transmission lines with d.c. power feeding. When overvoltage protection is applied to transformer coupled lines from the transformer center tap to ground, the total ground return current can be 200 A, 10/1000 and 1000 A, 2/10. The high 150 mA holding current is set above common d.c. feed system levels to allow the TISP4xxxJ3BJ to reset following a disturbance.

These devices TISP4xxxJ3BJ allow signal voltages, without clipping, up to the maximum off-state voltage value, VDRM, see Figure 1. Voltages above VDRM are limited and will not exceed the breakover voltage, V(BO), level. If sufficient current flows due to the overvoltage, the device switches into a low voltage on-state condition, which diverts the current from the overvoltage through the device. When the diverted current falls below the holding current, IH, level the devices switches off and restores normal system operation.