Features: ·Operation from 3.0V to 40V.·Short circuit current limiting.·Low standby current.·Output switch current of 1.5A without external transistors.·Frequency of operation from 100Hz to 100kHz.·Step-up, step-down or inverting switch regulators.PinoutSpecifications Rating Symbol Val...
TD34063: Features: ·Operation from 3.0V to 40V.·Short circuit current limiting.·Low standby current.·Output switch current of 1.5A without external transistors.·Frequency of operation from 100Hz to 100kHz.·S...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Rating |
Symbol |
Value |
Unit |
Power Supply Voltage |
VCC |
40 |
V |
Comparator Input Voltage Range |
VIR |
-0.3 to +40 |
V |
Switch Collector Voltage |
VC(switch) |
40 |
V |
Switch Emitter Voltage (Vpin 1 = 40 V) |
VE(switch) |
40 |
V |
Switch Collector to Emitter Voltage |
VCE(switch) |
40 |
V |
Driver Collector Voltage |
VC(driver) |
40 |
V |
Driver Collector Current (Note 1) |
IC(driver) |
100 |
mA |
Switch Current |
ISW |
1.5 |
A |
Power Dissipation and Thermal Characteristics TA = 25 Thermal Resistance |
PD RqJA |
1.0 100 |
W / W |
Operating Junction Temperature |
TJ |
+150 |
|
Operating Ambient Temperature Range |
TA |
0 to +70 |
|
Storage Temperature Range |
Tstg |
-65 to +150 |
NOTE : 1. Maximum package power dissipation limits must be observed. 2. ESD data available upon request. 3. Tlow = 0 , Thigh = +70 4. Low duty cycle pulse techniques are used during test to maintain junction temperature as close to ambient temperature as possible. 5.If the output switch is driven into hard saturation (non-Darlington configuration) at low switch currents ( 300mA) and high driver currents ( 30mA), it may take up to 2.0uS for it to come out of saturatiion. This condition will shorten the off time at frequencies 30kHz, and is magnified at high temperatures. This condition does not occur with a Darlington configuration, since the output switch cannot saturate. If a non-Darlington configuration is used, the following output drive condition is recommended: Forced of output switch:Ic output/Ic dirver-7.0mA*10 *The 100 resistor in the emitter of the driver device requires about 7.0 mA before the output switch conducts.
The TD34063 Series is a monolithic control circuit containing the primary functions required for DC to DC converters. These devices consist of an internal temperature compensated reference, comparator, controlled duty cycle oscillator with an active current limit circuit, driver and high current output switch. This series was specifically designed to be incorporated in Step-Down and Step-Up and Voltage-Inverting applications with a minimum number of external components.