TCM320AC36

` Single 5-V Operation
` Low Power Consumption:
   Operating Mode . . . 40 mW Typ
   Standby Mode . . . 5 mW Typ
   Power-Down Mode . . . 3 mW Typ
` Combined A/D, D/A, and Filters
` Extended Variable-Frequency Operation
   Sample Rates up to 16 kHz
   Pass-Band up to 7.2 kHz
` Electret Microphone Bias Reference Voltage Available
` Drive a Piezo Speaker Directly
` Compatible With All Digital Signal Processors (DSPs)
` Selectable Between 8-Bit Companded and 13-Bit (Dynamic Range) Linear Conversion:
   TCM320AC36 . . . m-Law and Linear Modes
   TCM320AC37 . . . A-Law and Linear Modes
` Programmable Volume Control in Linear Mode
` 300 Hz 3.6 kHz Passband with Specified Master Clock
` Designed for Standard 2.048-MHz Master Clock for U.S. Analog, U.S. Digital, CT2, DECT, GSM, and PCS Standards for
Hand-Held Battery-Powered Telephones

Supply voltage range, V_CC (see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.3 V to 7 V
Output voltage range at D_OUT, V_O . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.3 V to 7 V
Input voltage range at D_IN, V_I . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.3 V to 7 V
Continuous total power dissipation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . See Dissipation Rating Table
Operating free-air temperature range: C suffix . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .0 to 70
I suffix . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40 to 85
Storage temperature range, Tstg . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 65 to 150Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 260

† Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

NOTE 1: Voltage value is with respect to GND.