Features: ` Low supply current: IDD = 200A (typ.)` Single power supply operation` Wide common mode input voltage range: VSS~VDD−0.9V` Open drain output circuit` Low input bias current` Small packagePinoutSpecifications Characte...
TC75W59FU: Features: ` Low supply current: IDD = 200A (typ.)` Single power supply operation` Wide common mode input voltage range: VSS~VDD−0.9V` Open drain output ...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Characteristic | Symbol | Rating | N |
Supply voltage | VDD, VSS | ±3.5 or 7 | V |
Differential input voltage | DVIN | ±7 | V |
Input voltage | VIN | VSS~VDD | V |
Output current | IO | ±35 | mA |
Power dissipation | PD | 250 (TC75W59FU) |
mW |
200 (TC75W59FK) | |||
Operating temperature | Topr | −40~85 | °C |
Storage temperature | Tstg | −55~125 | °C |
Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the ignificant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings and the operating ranges.
Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook ("Handling Precautions"/"Derating Concept and Methods") and individual reliability data (i.e. reliability test report and estimated failure rate, etc).
Note: Since this product sometimes brings about latchcap, which is peculiar to CMOS devices, note the following points:
• Don't raise the voltage level of I/O pins beyond VDD, nor lower it below VSS. Consider the timing for power supply, too.
• Don't let any abnormal noise enter the device.
TC75W59FU is a CMOS type general-purpose dual comparator capable of single power supply operation and using lower supply currents than the conventional bipolar comparators. TC75W59FU's open drain output forms wired OR with other open drain outputs