Features: • Low Supply Current: IDD = 10 A (Typ.)• Single Power Supply Operation• Wide Common Mode Input : VSS~VDD − 0.9 V• Open-Drain Output Circuit• Low Input Bias Current• Small PackagePinoutSpecifications Characteristics Symbol Rating Unit S...
TC75S58AFE: Features: • Low Supply Current: IDD = 10 A (Typ.)• Single Power Supply Operation• Wide Common Mode Input : VSS~VDD − 0.9 V• Open-Drain Output Circuit• Low Input B...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Characteristics | Symbol | Rating | Unit | |
Supply Voltage | VDD, VSS | ±3.5 or 7 | V | |
Differential Input Voltage | DVIN | ±7 | V | |
Input Voltage | VIN | VSS~VDD | V | |
Output Current | IO | ±35 | mA | |
Output Voltage | VO | VSS ~ VSS + 7 | V | |
Power Dissipation | PD | TC75S58AFE | 100 | mW |
TC75S58AFC | 100(Note1) | |||
Operating Temperature | Topr | −40~85 | ||
Storage Temperature | Tstg | −55~125 |
Note: Due to the CMOS structure, this device may be susceptible to latch-up . To prevent latch-up, please take the following precautions;
• Ensure that no I/O pin's voltage level ever exceeds Vdd or drops below Vss. In addition, check the power-on timing.
• Do not subject the device to excessive noise.
(Note1):FR4 in board implementation
(25.4mm * 25.4mm * 1.6t, Cu Pad: 0.4mm2)
The TC75S58AFE and TC75S58AFC are CMOS general-purpose single comparators. The devices can operate from a single supply voltage and are designed for a lower supply-current than conventional general-purpose bipolar comparators. The output is designed for Open-Drain Output and can supply a higher voltage than the power supply. Therefore, TC75S58AFE is possible to pull-up the voltage to a level higher than that of the power supply. The Open-Drain Output can be wired-OR with another Open-Drain Output circuit.
* Output voltage should not exceed the maximum rating