Features: • High speed: fmax = 150 MHz (typ.) at VCC = 5 V• Low power dissipation: ICC = 8 A (max) at Ta = 25• High noise immunity: VNIH = VNIL = 28% VCC (min)• Symmetrical output impedance: |IOH| = IOL = 24 mA (min)Capability of driving 50 tansmission lines.• Balance...
TC74AC299F: Features: • High speed: fmax = 150 MHz (typ.) at VCC = 5 V• Low power dissipation: ICC = 8 A (max) at Ta = 25• High noise immunity: VNIH = VNIL = 28% VCC (min)• Symmetrical o...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Characteristics |
Symbol |
Rating |
Unit |
Supply voltage range |
VCC |
−0.5 to 7.0 |
V |
DC input voltage |
VIN |
−0.5 to VCC + 0.5 |
V |
DC output voltage |
VOUT |
−0.5 to VCC + 0.5 |
V |
Input diode current |
IIK |
±20 |
mA |
Output diode current |
IOK |
±50 |
mA |
DC output current |
IOUT |
±50 |
mA |
DC VCC/ground current |
ICC |
±250 |
mA |
Power dissipation |
PD |
500 (DIP) (Note 2)/180 (SOP) |
mW |
Storage temperature |
Tstg |
−65 to 150 |
Note 1: Exceeding any of the absolute maximum ratings, even briefly, lead to deterioration in IC performance or even destruction.
Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings and the operating ranges.
Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook ("Handling Precautions"/Derating Concept and Methods) and individual reliability data (i.e. reliability test report and estimated failure rate, etc).
Note 2: 500 mW in the range of Ta = −40 to 65. From Ta = 65 to 85 a derating factor of −10 mW/should be
applied up to 300 mW.
The TC74AC299F is an advanced high speed CMOS 8-BIT PIPO SHIFT REGISTER fabricated with silicon gate and double-layer metal wiring C2MOS technology.
It achieves the high speed operation similar to equivalent Bipolar Schottky TTL while maintaining the CMOS low power dissipation.
TC74AC299F has a four modes (HOLD, SHIFT LEFT, SHIFT RIGHT and LOAD DATA) controlled by the two selection inputs (S0, S1). When one or both enable (G1 , G2 ) are high, the eight I/O outputs are forced to the high-impedance state; however, sequential operation or clearing of the register is not affected. All inputs are equipped with protection circuits against static discharge or transient excess voltage.