On-State RMS Current (It RMS)
:
Mounting Style
: Through Hole
Gate Trigger Current (Igt)
: 10 mA
Off-State Leakage Current @ VDRM IDRM
: 0.01 mA
Holding Current (Ih Max)
: 30 mA
Packaging
: Box
Package / Case
: TO-225
Rated Repetitive Off-State Voltage VDRM
: 200 V
Breakover Current IBO Max
: 25 A
Gate Trigger Voltage (Vgt)
: 2.2 V
Features: • Very High Gate Sensitivity
• Low On-State Voltage at High Current Levels
• Glass-Passivated Chip for Stability
• Small, Rugged Thermopad Construction for Low Thermal Resistance, High Heat Dissipation and Durability
• Pb−Free Package is Available*
Specifications
|
Rating |
Symbol |
Value |
Unit |
Peak Repetitive Off-State Voltage (Note 1)
(TJ = 25 to 110, Gate Open) |
VDRM,
VRRM |
200 |
V |
On-State RMS Current (TC = 70)
(Full Cycle Sine Wave 50 to 60 Hz) |
IT(RMS) |
2.5 |
A |
Peak Non−Repetitive Surge Current (One
Full Cycle, Sine Wave 60 Hz, TC = 70) |
ITSM |
25 |
A |
| Circuit Fusing Consideration (t = 8.3 ms) |
I2t |
2.6 |
A2s |
Peak Gate Power
(Pulse Width 10s, TC = 70) |
PGM |
10 |
W |
| Average Gate Power (t = 8.3 ms, TC = 70) |
PG(AV) |
0.5 |
W |
Peak Gate Current
(Pulse Width 10s, TC = 70) |
IGM |
0.5 |
A |
| Operating Junction Temperature Range |
TJ |
−40 to +110 |
|
| Storage Temperature Range |
Tstg |
−40 to +150 |
|
| Mounting Torque (6-32 Screw) (Note 2) |
− |
8.0 |
in. lb. |
Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only.
Functional operation above the Recommended Operating Conditions is not implied. Extended exposure to
stresses above the Recommended Operating Conditions may affect device reliability.
1. VDRM and VRRM for all types can be applied on a continuous basis. Blocking voltages shall not be tested
with a constant current source such that the voltage ratings of the devices are exceeded.
2. Torque rating applies with use of torque washer (Shakeproof WD19523 or equivalent). Mounting Torque
in excess of 6 in. lb. does not appreciably lower case-to-sink thermal resistance. Main terminal 2 and heat-
sink contact pad are common.
DescriptionT2322B is designed primarily for ac power switching. The gate sensitivity of these triacs permits the use of economical transistorized or integrated circuit control circuits, and T2322B enhances their use in low-power phase control and load-switching applications.
T2322B Data Sheet
