Features: · Desktop mounted parallel port to JTAG interface· Standard 25 way D-type parallel port connection· Standard 26 way D-type differential OS-Link port for connection to a B300.· Standard 20 way IDC cable for JTAG connection.· Plug top power supply· Supports nibble, byte and EPP mode parall...
ST20-JPI: Features: · Desktop mounted parallel port to JTAG interface· Standard 25 way D-type parallel port connection· Standard 26 way D-type differential OS-Link port for connection to a B300.· Standard 20 ...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Features: · C++ cross-development for IBM PC and Sun 4 hosts.· Conformance with the C++ 3.0 specif...
The ST20-JPI parallel port to JTAG interface is a host interface to allow connection from a PC parallel port to any JTAG diagnostic controller based ST20 development board. The interface plugs into any standard PC 25 way D-type parallel port. Supported parallel port modes are:
· Nibble mode
· Byte mode
· EPP mode
depending on which mode the host PC can support. Connection to the development target is via a 20 way IDC JTAG connector. Once connected, the development target can be accessed using the MS Windows drivers supplied with the standard ST20 toolset.